Advertisement
Advertisement
Table of Contents
Summary of Contents for Naomoto HSP Series
- Page 1 NAOMOTO ALL STEAM IRON HSP series INSTRUCTION MANUAL HSP - 440...
-
Page 2: Table Of Contents
INTRODUCTION 5. Please note that, as a result of our ongoing We thank you for your purchase of NAOMOTO vigorous efforts to improve our products, some Model HSP-440 All Steam Iron. specifications of the machine you have purchased may slightly differ from those This Instruction Manual is a guide book for mentioned in this manual. -
Page 3: Specifications
1. SPECIFICATION MODEL HSP-140 WORKING STEAM 0.1 — 0.5 MPa PRESSURE (1 — 5 bar) STEAM VALVE PUSH LEVER TYPE WEIGHT 1.1 kg BASE-PLATE SIZE 203mm X 99mm BODY TREATMENT “TUFRAM” 2. ATTACHMENT & ACCESSORIES The following attachments and accessories are packaged in the same carton as the Iron. -
Page 4: Precautions Before Operation
4. PRECAUTIONS BEFORE OPERATION 4.1 Application This iron is intended to be be used exclusively for the ironing of textile fabrics and/or garments. Please do not use it for any purpose other than the above-mentioned. This iron is for professional and industrial use, not for household use, and it requires steam supplied from a steam-boiler. -
Page 5: Install & Assemble
CAUTION Please do not use any other steam supply hose than the Naomoto Extra- Hose especially for steam pressure that does not exceed 0.3 MPa (3 bar). Naoflon hose should be used for the drain hose. Use of a non- genuine hose of which proof pressure is not confirmed may cause malfunction. - Page 6 Valve Check Valve Connect the end of the drain supply hose to the drain intake of the boiler. If a NAOMOTO Steam Trap NBC-series light-type boiler is used, be sure to Packing...
-
Page 7: Ironing Operation
6. IRONING OPERATION CAUTION When starting and finishing operation, follow Sole plate temperature of all steam iron the instructions below. To ensure the correct as this product is controlled by the steam operation of the iron, read also the instruction pressure of the boiler. -
Page 8: Maintenance & Checking
- If you have any problems with the equipment, please check the symptoms and take necessary countermeasures outlined below where applicable. - If you need to replace any parts, ask the nearest NAOMOTO office or its agent for the replacement parts. - Page 9 - Remove valve joint with spanner. (ie. the steam-flow can be increased turning the screw counter-clockwise). - Further, remove wire, teflon bushing, O-ring, Decrease Increase spindle washer and spring on this turn (see below drawing). - After finishing checking and replacement, Plastic Nut assemble on the reverse turn.
Need help?
Do you have a question about the HSP Series and is the answer not in the manual?
Questions and answers