Summary of Contents for Janitor JV500
- Page 1 LIGHTWEIGHT AT ONLY 4.6KG GULPER FLOOR HEAD FOR MULTI SURFACE CLEANING POWERFUL MOTOR 1200W MOTOR LARGE CAPACITY 4 LITRE CAPACITY...
-
Page 2: Table Of Contents
Assembly ........................9 Instructions For Use ..................... 11 Maintenance ......................13 Troubleshooting ....................16 Congratulations on the purchase of your new Janitor JV500 Backpack Parts List ........................ 17 Vacuum Cleaner. Your Janitor JV500 Backpack has been manufactured Conditions of Warranty ..................18 to the highest quality and performance standards. -
Page 3: Components List
5. Cloth Filter Bag 12. Gulper Floor Tool 18. Filter Latch Working Radius: 8m Weight: 4.6KG (unit & hose only) 6. Pre-Motor Sponge Filter 13. Exhaust Filter 19. Accessories Holder 7. Dust Bin Lid Latch 20. Cord Hook JANITOR JV500 JANITOR JV500 5... -
Page 4: Before You Begin
Do not pull or carrying the appliance by the power cable, use the power cable as qualified technician. a handle or pull the power cable around shaft edges or corners. Avoid running the appliance over the power cable. JANITOR JV500 JANITOR JV500 7... - Page 5 Before carrying out any maintenance service or cleaning the filters, always switch off the vacuum cleaner and disconnect the plug from power supply. Keep ends of the hose, 2-piece rod and other openings away from your face and body. Carpet Hard Floors JANITOR JV500 JANITOR JV500 9...
-
Page 6: Assembly
IMPORTANT TO YOUR NEAREST GODFREYS STORE IF THE MOTOR IS FAULTY OR IF THE CORDS The unit is ergonomically correct when the ARE DAMAGED. weight is distributed over the waist and not on the shoulders. JANITOR JV500 JANITOR JV500 11... - Page 7 Suction Relief Valve 1. If the floor tool becomes difficult to move during 2. Remove the dust bin lid to access the dust bag. vacuuming, adjust the Air Relief Valve to reduce the suction pressure. JANITOR JV500 JANITOR JV500 13...
-
Page 8: Maintenance
2. Replace the exhaust filter and ensure that the Filter Grille is NOTE: For maximum performance replace the cloth filter bag reinstalled securely. every 3 months. NOTE: It is recommended to replace the filter every 6 months or when it becomes visibly dirty. JANITOR JV500 JANITOR JV500 15... -
Page 9: Troubleshooting
(Important: always first remove the plug from the back on. Mains power point). JANITOR JV500 JANITOR JV500 17... -
Page 10: Conditions Of Warranty
To find out more about our range, from the use of non-genuine parts. If any part is no longer email: customerservice@godfreys.com.au available or manufactured, Electrical Home-Aids Pty Ltd will replace it with a genuine functional replacement part. JANITOR JV500 JANITOR JV500 19... - Page 11 11500179 V3 7/19...
Need help?
Do you have a question about the JV500 and is the answer not in the manual?
Questions and answers
How do i fit a new back brass on my vacuum
To fit a new back brace (backpack harness) on a Janitor JV500 vacuum:
1. Loosen all harness straps.
2. Put your arms through the harness.
3. Buckle the hip belt so the backpack rests on your hip bones.
4. Tighten the hip belt by pulling the side straps.
5. Tighten the shoulder straps by pulling down on the strap ends.
6. Buckle and adjust the sternum strap across your chest.
This answer is automatically generated