Sundstrand Micropace MP-100 Series Instruction Sheet

Micropace™ Electronic Metering Control Modules
Specifications and dimensions shown above are typical for all models. Specifications and dimensions shown above are typical for all models. Specifications and dimensions shown above are typical for all models. Specifications and dimensions shown above are typical for all models. Specifications and dimensions shown above are typical for all models.

MP-100 Analog to Digital Converter

Input Signal Source: 4-20 mA (isolated) only.
Max Input Voltage: 42VDC
Impedance: 100 Ohms
Installation
1. Disconnect signal source supply voltage prior to
connecting your MP-100. Failure to do so may damage
the MP-100 circuit.
2. Insert the 4-pin connector into the socket on your LMI
Series A7, B7 or C7 Metering Pump. The socket is
located on the bottom right under the pump control
panel.
3. Connect the other end of the cable to your input
signal source. Polarity is:
white = positive(+); black = negative (-).
LIQUID METRONICS DIVISION
™
MICROPACE ®
MP-100 Series Loop Control
Instruction Instruction
Instruction Instruction Instruction
Power Supply:
15 VDC, Supplied by
LMI pump
Ambient Temperature:
0
(-20
Enclosure:
Splash & dust proof,
IP-65 rated
Percent
Pump
Speed
4 6 8 10 12 14 16 18 20
milliAmp DC Signal
MP-100 Adjustment Range
LIQUID METRONICS DIVISION
MICROPACE
4 DIGIT MULTIPLIER
MODEL MP-500M
MP-100 Typical Installation
Sheet Sheet
Sheet Sheet Sheet
F to 140 F
0 0
C to 60 C)
0 0
Span (range)
adjustment by
stroke length
Replaces same of Rev. B 5/96
1631.B 7/97