Scanmarker Air Installation And Operation Instructions

Air
Air

LED Indications

Scanmarker Air has three controls:The device's Tip and
two colored, Blue and Green LEDs.
The Blue and Green LEDs indicate status
BLUE LED (Wireless - Bluetooth connectivity)
Status
State
Connected
Steady Light ("On")
No light ("Off") Not connected
Blinking Searching and pairing with host
If the blue LED of the Scanmarker Air is on, but you don't see it on your
device (computer or smartphone) App, make sure it is not connected to
another host (other computer or smartphone of yours)
GREEN LED (Battery status)
State Status
Steady Light ("On") Charged
Low battery – charging is required
Blinking (fast)
Blinking (slow bursts) Charging. Turns to steady light
when battery is full
© Copyright 2015
Scanmarker is a registered Trademark of Topscan Ltd.
TM
All software, hardware, design and implementations are copyright 2015
by Topscan Ltd. All rights reserved
Air

Installation

and Operation
Instructions
Installation
Plug into a computer USB port or use a USB charger.
Mac and Windows
Download the relevant application from www.scanmarker.com/download
• Scanmarker Air can connect to computer either via USB or by the
• Connect your Scanmarker Air only after installing the software.
Mobile
IOS: Search for 'Scanmarker Air' app in App Store and install on device.
Launch app and follow on-screen instructions.
Android: Search for 'Scanmarker Air' app in Play Store and install
on device. Launch app and follow on screen instructions.
Power On/Off
Press tip gently
TO TURN ON:
against a surface for two seconds.
Tap the tip three
TO TURN OFF:
times (quickly and gently) against a
surface.
After being inactive for 12 minutes, the Scanmarker Air will auto-power off.
Turn it back on to resume scanning.
Air
Blue-tooth dongle.
TO TURN OFF
TO TURN ON