Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for ZiFiSense APZT-UI01
- Page 1 ZETA AP ZETA AP...
- Page 2 ZETA AP Copyright Statement ZiFiSense owns the copyright on this specification. No part of this specification may be reproduced in any form or means, without the prior written consent of ZiFiSense. Disclaimer This specification is preliminary and is subject to change at any time without prior notice.
-
Page 3: Table Of Contents
ZETA AP Table of Contents....................3 Table of Contents 1. Product Description..................4 2. Applications.....................4 4. Device Specifications..................5 3. Appearance & Interface................4 5. Installation......................6 5.1. Installation safety notice..............6 5.2. Installation environment check............6 5.3. Installation tool..................6 5.4. Installation steps.................7 6.1. -
Page 4: Product Description
ZETA AP 1. Product Description ZETA IIoT gateway, supporting LPWAN ZETA protocol, to meet the full range of ZETA sensor device access. Ethernet or Cellular link way to connect to the cloud platform, while supporting sensor data back through BACnet, MODBUS and other protocols. It can be widely used in different industrial data communication scenarios, such as: energy, transportation, municipal, agriculture, etc. -
Page 5: Device Specifications
ZETA AP 4. Device Specifications Model No. APZT-UI01/APZT-GI01/APTG-GI01 Protocol ZETA Frequency band 920-925 Wireless Output power 20±3 mW Number of channels 61 Power supply DC 5-12V Electrical Power ≤5W Size 137*124*30mm Enclosure material SPCC Physical Ingress level IP30 Antenna External Antenna... -
Page 6: Installation
ZETA AP 5. Installation It is forbidden to operate with electricity when installing, wiring and 5.1. Installation safety notice dismantling the equipment. Place the equipment in a ventilated place to ensure that the equipment is installed in a dry environment. ... -
Page 7: Installation Steps
ZETA AP 1) Confirm the installation hole spacing: the four-corner hole can be used 5.4. Installation steps for fixed installation. 2) Use the supporting expansion screws to fix the equipment on the wall of the building. 3) Connect the RF antenna and the 4G antenna. The GPS antenna may not Figure 2: Installation diagram be connected when it is installed in a fixed place in the indoor environment. -
Page 8: System Testing
ZETA AP 6. System Testing After power-on, observe the status of the indicator lights next to the power 6.1. Check after power-on interface, and note that the lower two indicator lights are enabled. The specific functions are shown in the figure below.。 Figure 4: Schematic diagram of power indicator After the indicator shows normal, the installation information can be 6.2. -
Page 9: Common Faults And Handling
Check whether the heartbeat packet of the gateway (once per minute) is normal. If it still does not work, you can power it on again, start the gateway device, and check to see if it is restored. Contact ZiFiSense for more solutions. - Page 10 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
- Page 11 ZETA AP...