Summary of Contents for Open Flight Solutions FlightBox Pro v2
- Page 1 FlightBox Pro Installation Manual Revision F - Covers FlightBox Pro v2 (FB1XP2) 8/27/2018 Copyright 2018 - Open Flight Solutions...
- Page 2 Due to the wide variation in aircraft, this document only provides a general overview. For additional information, please contact Open Flight Solutions. Open Flight Solutions 10649 Nathanson Ave. Cupertino, CA 95014 (816) 336-9447 support@openflightsolutions.com Page 2 of 10 Copyright 2017 Open Flight Solutions...
-
Page 3: System Parameters
Input Voltage 14v or 28v Minimum Input Voltage Maximum Input Voltage Current Draw 0.5 A nominal / 0.75 A max (at 13.8v) Circuit Breaker / Fuse Environmental Storage High Temperature +85° C Page 3 of 10 Copyright 2017 Open Flight Solutions... -
Page 4: Restrictions And Limitations
This system can be installed by any FAA approved repair station or certificated A&P mechanic. In the event of a system failure it must be returned to Open Flight Solutions for repair. Failure to adhere to this policy will void the warranty. (See the Warranty section below for details.) -
Page 5: Recommended Installation Locations
20 gauge MIL-W- 22759/16 or equivalent wire. 4. Insert the barrel connector on the wiring harness into the barrel jack on the FlightBox Pro and tighten the locking collar. Page 5 of 10 Copyright 2017 Open Flight Solutions... - Page 6 The Open Flight Solutions remote antenna mount kit allows the antennas to be mounted either using suction cups or permanent fasteners. The mount and antennas should be located such that they do not obscure the pilot’s field of view.
- Page 7 7.3.2 GPS Installation Each FlightBox Pro v2 system includes a GPS receiver module suitable for mounting on the glare shield or elsewhere on the aircraft. The included USB GPS receiver module should be securely mounted on the glare shield or in another interior location with a clear view of the sky.
-
Page 8: Post-Installation Checks
ADS-B signals. Refer to the FlightBox Pro User’s Guide for further information. NOTE: The cooling fan is controlled by an onboard thermostat and may not immediately spin up depending on the temperature. Page 8 of 10 Copyright 2017 Open Flight Solutions... -
Page 9: Maintenance
No operational credit may be taken for installation of FlightBox Pro. Modification or update of system operating software by the end user is prohibited. 12. Performance The installation and operation of FlightBox Pro v2 has no appreciable impact on aircraft performance. 13. Unit Failure Conditions No visual or aural failure indication is available. - Page 10 Other than the cost of postage, no charge will be made for replacement of the defective product. Important: Do not attempt to open unit. If unit is opened, warranty will be void. Appropriate insurance coverage is your responsibility. Consult your insurance agent. Page 10 of 10 Copyright 2017 Open Flight Solutions...