Wupi WIC501 Product Instruction Manual

01 / Product Parameters

Model: WIC501
5V*2A/9V*2A/12V*2A
Input:
5V*1A /
Output:
Frequency: 110KHz~205KHz
Ambient temperature:

02 / Operation Method

1. Install the Wupi wireless chargers WIC501 on the Wupi motorcycles bracket, and
insert the USB terminal into the USB charger interface of the Wupi motorcycles.
2. In order to start wireless charging for the phone，please make sure the wireless
receiving position of phone is placed correctly on the transmitting range of the
wireless charger,then press the USB switch of the Wupi wireless chargers to start
charging(Usually the wireless receiving position is at the center of the phone);
3. When the charging is completed or the charging needs to be stopped, press the
USB switch of theWupi wireless charger again, and the indicator light will go out.
Note: This wireless charger is not limited to use on motorcycles only.

03/ Indicator LED

Stand-by
Working--Fast
charging
Working--Slow
charging
Metal foreign objects
detected
or Insufficient input
powerout
or deviation from the
right position

04/ Notes:

1. Please make sure the phone is placed on the center of the wireless charger.
Deviation from the center will decrease the charging efficiency or interrupt the
charging.
2. It should be less than 4mm for the thickness of the phone case, and there should
be no foreign metal objects in the charging area between the phone and wireless
WIC501 Wireless Charger
Product Instruction Manual
9V*1.67A /12V*1.2A
-5℃－40℃
Blue light always on
Red light always on
Blue light flashes
Red light flashes