Summary of Contents for nolitto3d CLIXBEETLE-PRO
- Page 1 Nolitto3d Tactile Feedback Mod for the Thrustmaster TH8A/RS CLIXBEETLE-PRO CLIXBEETLE-GT INSTALLATION INSTRUCTIONS FOR THE CXBT-PRO AND CXBT-GT © nolitto3d 2020...
- Page 2 Clixbeetle-Pro (CXBT-PRO) and Clixbeetle-GT (CXBT-GT) Installation Instructions Make sure the TH8A/RS Shifter is disconnected/unplugged when installing the Clixbeetle 1. Unscrew (turn counter clockwise) & remove the gearstick knob 2. Remove the 4 screws holding the metal gated plate © nolitto3d 2020...
- Page 3 4. Carefully lift the plastic plate with the cloth as shown below, taking care not to pull on the black cable The black cable connects to the little switch on the black plastic plate. It is used for when you configure the shifter in Sequential Mode. © nolitto3d 2020...
- Page 4 If this is the case, then you would have to snip/cut the cable tie first, then pull the cloth ring over the gearstick. Be very careful not to cut/snip the black cable. © nolitto3d 2020...
- Page 5 Clixbeetle 6. Put some grease (e.g. General Purpose Lithium Grease, White Lithium Grease, Silicone Grease, Moly/Molybdenum Disulphide Grease – In the photos I’m using Moly Grease) on the front and back of the Clixbeetle as shown below: © nolitto3d 2020...
- Page 6 Make sure the Clixbeetle is pushed all the way down until it touches/sits firmly on the bottom metal pivot shaft WARNING: The Clixbeetle-Pro (CXBT-PRO) has already been calibrated for optimal tactile feedback (screws are glued and not adjustable). Only the Clixbeetle-GT (CXBT-GT) has adjustable spring pressure screws (use the Clixbeetle-GT Ball Bearing Spring Pressure Adjustment instructions).
- Page 7 8. Slide the gearstick forward and back, so you can put some grease on the steel ball bearings as shown Wipe off excess grease and clean the top of the Clixbeetle and also clean the gearstick so you can insert the ratchet clip as shown on the next page. © nolitto3d 2020...
- Page 8 9. Slide the ratchet clip down the gear-stick and make sure it is sitting/touching the top of the Clixbeetle-Pro. Tighten the ratchet clip with a pair of pliers as tight as possible (until the teeth can no longer engage) to prevent the Clixbeetle from sliding up.
- Page 9 NOTE: Do not put a cable tie back on the black sequential switch cable, just make sure it is out of the way when putting the gated plates/covers back on, so that the gearstick can slide unobstructed when pushed sideways. Older version of clip shown Start your engines! © nolitto3d 2020...