Novii FluxxLED IP54 Bulkhead Installation Manual

Time setting
S3 S4 S5 TIME
The light can be set to stay ON for any period of time between approx. 10sec
0 0 0 10s
and a maximum of 30min. Any movement detected before this time elapse will
0 0 1 1min
re-start the timer. It is recommended to select the shortest time for adjusting the
0 1 0 5min
detection zone and for performing the walk test.
Pull switch to the ON position as "1", pull switch to the OFF position as "0",
0 1 1 10min
switch location and detection range of the corresponding table is as follows:
1 0 0 15min
NOTE: after the light switches OFF, it takes approx. 4sec before it is able to
1 0 1 20min
start detecting movement again. The light will only switch on in response to
1 1 0 25min
movement once this period has elapsed.
1 1 1 30min
Light-control setting
S6 S7 S8 LUX
The chosen light response threshold can be infinlitely from approx. 10-500lux,
0 0 0 24H
pull switch to the ON position as "1", pull switch to the OFF position as "0",
switch location and light-control of the corresponding table is as follows:
0 0 1 10LUX
0 1 0 20LUX
0 1 1 50LUX
1 0 0 100LUX
200LUX
1 0 1
1 1 0 300LUX
1 1 1 500LUX
Hold time "A" please refere to "TIME SETTING" table
page 4
Outside of
detection
area
L IP54 Bulkhead Installation Manual ED CEILING LIGHT USER GUIDE
L
ED CEILING LIGHT USER GUIDE