Home Storage Space Wire Shelving Rack A35BA-1 Assembly Instructions

Before returning to your retailer, CALL OUR CUSTOMER SERVICE DEPARTMENT at
1-866-375-7994, 9 a.m. - 5 p.m. EST. MONDAY- FRIDAY. E-Mail:customerservicegsm@sbcglobal.net

Tools Required For Assembly

No tools required for assembly.
Helpful - Rubber Mallet
Note: Black plastic discs used for packing only - Discard

SPECIAL WARNINGS

Assemble the item on a soft, non-abrasive surface, such as carpeting, to avoid scratching the finish.
Use care when handling. May require two adults for safe assembly.

CARE AND MAINTENANCE

Periodically check and make sure that all components are in their proper position, are free from damage and that all connectors are tight.
ASSEMBLY INSTRUCTIONS
Start with the bottom shelf and choose the desired height.
Note: Bottom shelf should be no more than six inches from the floor.
Step 1
Snap the two halves of a plastic tapered lock (B) with the tapered
end facing up, at the desired height on bottom pole (D). Be sure to
install the plastic tapered locks (B) at the same height.
Pay close attention to using the same groove lines
Step 2
Rest shelf (A) on its side on the floor (shelf lip facing down) and
slide the four bottom poles (D) (top pole end first) through the
holes on the corners of the shelf.
Step 3
Turn the unit upright and push the shelf firmly into place so the
shelf is resting on the plastic tapered locks (B).
Step 4
Install the 2nd shelf (A) repeating the instructions in step 1.
Install shelf on the poles and push the shelf firmly into place so the
shelf is resting on the plastic tapered lock (B)
Assembly Instructions
Questions, Problems, Missing Parts?
Parts List (B)
A (4) Shelf
B (16) Plastic Tapered Lock Sets + (2) sets extra
C (4) Top Poles
(with pole connector & caps Pre-installed)
D (4) Bottom Poles
(with levelers pre-installed)
Estimated Assembly Time: Approximately 20 minutes
on all four poles.
Item# A35BA-1
4 Shelf Wire Shelving Rack
Connector
Leveling Foot
1
3
2
D
D
B
D
4
Cap
A
D
D
08/21/12