Crossover Symmetry Wall Mounts Install Manual

Heavy Duty Permanent Attachment Anchors
Crossover Symmmetry's Wall Mounts™ provide a high traffic, commercial grade workout station that can safely
anchor heavy resistance training accessories and Crossover Cords™ to add functionality to performance facilities.

INSTALL GUIDE FOR WOOD STUDS

INCLUDED HARDWARE: (1 SET)
A

TOOLS NEEDED:

In order to install CS Wall Mounts™ on a wooden surface, you will need a tape measure, a pencil, a level, and
a power drill with a 9/16" socket and a 1/4" drill bit (in order to make lead holes).

CONCRETE AND METAL INSTALL INSTRUCTIONS:

DO NOT ATTEMPT TO INSTALL ON METAL OR CONCRETE SURFACES WITH THE INCLUDED
HARDWARE SET, you will need to purchase additional hardware. For specifications and alternate install
instructions, please visit GoCrossover.com or write info@crossoversymmetry.com
WARNING:
THE USE OF THE REQUIRED TOOLS MAY PRESENT AN INHERENT DANGER TO THE PARTICIPANT. READ ALL INSTRUCTIONS BEFORE
BEGINNING. IF YOU DO NOT FEEL COMPETENT TO ASSEMBLE OR MOUNT THE INCLUDED EQUIPMENT, SEEK ASSISTANCE. DO NOT RUSH. FOLLOW
INSTRUCTIONS AS OUTLINED IN THIS GUIDE. ALWAYS CHECK YOUR EQUIPMENT THOROUGHLY AND INSPECT FOR DEFECTS. IF ANY DEFECTS ARE
FOUND, DISCONTINUE USE OF THE PRODUCT. ALL CROSSOVER SYMMETRY EQUIPMENT IS INTENDED TO BE USED ONLY IN THE MANNER SHOWN
IN THE INCLUDED INSTRUCTIONAL MATERIALS. CONTACT US AT WWW.CROSSOVERSYMMETRY.COM WITH ANY QUESTIONS REGARDING THE
READ ALL INSTRUCTIONS BEFORE BEGINNING
ENCLOSED EQUIPMENT OR ITS INTENDED USES.
B
8
INSTALL HARDWARE
WOOD STUDS
Qty.4
( )
OFFICIAL PRODUCT OF CROSSOVER SYMMETRY
2