Download Print this page

WilliamsRDM Stove Top Fire Stop STFS PLUS LC User Manual page 2

Automatic fire suppression for grease fires on indoor residential stove tops (class k)

Advertisement

REQUIREMENT - HEIGHT/ALIGNMENT
MICROWAVE
COOKTOP
Each canister must be able to mount
independently to the underside of the
microwave at the midpoint between center
of the front and back burners on each side
(left and right) at a distance of 15-32"
(38-81 cm) above the surface of the stove.
MICROWAVE
Underside
FRONT
View
REAR
VENTS: Canisters should not be mounted over any vents, if possible. The ClickBar and magnets may do so, but only if it permits the device to
meet the three (3) magnet minimum requirement. Some metallic parts under the microwave may not hold a magnet.
LIGHTS: Neither glass nor plastic light covers will hold a magnet. Canisters or ClickBars may obstruct the light, provided that the three (3)
magnet requirement has been met, and the unit is secure.
STEP 1
REAR
COOKTOP
Overhead
View
FRONT
Position the canisters on the stove where
the canisters sit at the midpoint between
the center of the front and back burners on
each side. The ClickBar need only be able
to be raised without obstructions.
STEP 4
MICROWAVE
Front View
Once you have found an acceptable
location, lift the ClickBar upwards.
Confirm that three (3) of the five (5)
magnets are securely fastened.
INSTALLATION INSTRUCTIONS
To accommodate many different
microwave configurations,
each ClickBar
contains five (5)
magnets. At least three (3) of the
15-32"
38-81 cm
five (5) magnets must make full,
strong contact with a flat surface
on the underside of the microwave.
NOTE: Magnets making contact
with ridges, support ribs, valleys,
non-magnetic parts, and rounded
or angled sections should not be
counted on.
REQUIREMENT - PRECHECK MICROWAVE
COOKING
AREA
Side
View
REAR
Raise canisters from underneath to the
spot directly above under microwave
without attaching the ClickBar.
Due to variances in stove design and
element layout, the canisters may not
perfectly align with each other under
the microwave.
REQUIREMENT - MOUNTING
Below are just some of the possible scenarios. Microwave detail is not drawn to scale.
Not Attached
Not Attached
Attached
STEP 2
MICROWAVE
FRONT
COOKTOP
STEP 5
MICROWAVE
REAR
MICROWAVE
REAR
MICROWAVE
REAR
STEP 3
FRONT
MICROWAVE
Underside
View
REAR
Use one hand to hold the canister in its
final position, while using the other hand
to swivel the ClickBar to the optimal
mounting position (see precheck section).
STEP 6
Place the enclosed decal under or near
the microwave where it can be seen.
679-LC-35 Rev D, 01/2020
FRONT
FRONT
FRONT
FRONT
REAR

Advertisement

loading