Advertisement
Quick Links
Advertisement
Summary of Contents for Little E Kids Electric Balance Bike
-
Page 2: Table Of Contents
Contents Little e Kids Electric Balance Bike Cautions---------------------------------------------------------------------------------------------------------------------------------------------------------2 Bike Components------------------------------------------------------------------------------------------------------------------------------------------------3 Bike Assembly--------------------------------------------------------------------------------------------------------------------------------------------------4-5 Using your bike------------------------------------------------------------------------------------------------------------------------------------------------6-12 Maintaining your bike---------------------------------------------------------------------------------------------------------------------------------------- 13-18... -
Page 3: Cautions
Instructions Little e Kids Electric Balance Bike MANUAL 1.Note: the product pictures are for illustrative purposes only. These pictures may not reflect the exact look of actual product. Specifications may change. Before using the bike, please read the manual carefully and ensure all the parts are in good condition, to ensure rider safety. If any problem is encountered, please contact the dealer immediately. -
Page 4: Bike Components
Bike Components Little e Kids Electric Balance Bike 1.Front wheel 2.Tire 3.Front fork 4.Stem 5. Frame 6.Saddle 7. Seat post 8.Inner tube 9.Rear wheel 10.Chain adjuster 11.Chain cover 12.Side cover 13.Controller 14.Battery 15.Seat post release 16.Throttle 17.Handlebar 18.Left brake lever 19.Left grip... -
Page 5: Bike Assembly
Bike Assembly Little e Kids Electric Balance Bike 1. Remove the bike from the carton and remove all the packaging. Fix the handlebar into the stem tightly (5-6Nm) with a hex wrench. 2. Installation requirements: 2.1 The handlebar needs to be symmetrical in the stem (left to right) 2.2 Once symmetrical, rotate the bar back or forward until the brake levers are... - Page 6 Bike Assembly Little e Kids Electric Balance Bike To install the front wheel, first remove the wheel nuts and locking washers. Slide the axle into the fork dropouts. Place the locking washers, tab side in, over the axle and into the locking hole in the fork. Refit the wheel nuts and tighten, either with a 13mm or 15mm depending on the...
-
Page 7: Using Your Bike
Using Your Bike Little e Kids Electric Balance Bike 1. While riding, please wear the appropriate safety equipment, a helmet and covered footwear is compulsory, items such as knee and elbow pads are advised at the user’s discretion 2. Throttle/Display functions... - Page 8 Using Your Bike Little e Kids Electric Balance Bike 2.2. To turn the bike on, press the power button. The amount of battery charge will be displayed through the coloured LED lights on the display as shown above. To activate the motor and ride the bike, first ensure you are ready with your personal protective equipment and in a safe environment, then mount the bike.
- Page 9 Using Your Bike Little e Kids Electric Balance Bike 4. Removal and refitting of the battery: First ensure the bike is turned off on the display. Then gently tip the bike over onto its side. On the bottom you will find a rubber cover/dust boot on the bottom of the battery as shown in the picture below.
- Page 10 Using Your Bike Little e Kids Electric Balance Bike To reinstall the battery, first ensure that the locking pin is located on the top, pointing towards the seat as shown in the picture below. Once this is confirmed, simply align the battery with the cavity and rails in the frame (also shown in the pictures below) and push gently. Once the battery is all the way into the frame, turn the key to lock it in place.
- Page 11 Using Your Bike Little e Kids Electric Balance Bike The locking pin on the top of the battery...
- Page 12 5. Speed limit instructions: The Little e Kids Electric Balance Bike comes with two speed settings which the owner can define. One safe/learner speed of 9KM/H, and one unrestricted speed of 18KM/H. It is recommended that the operation of the speed limit switch is only carried out by an adult.
- Page 13 Using Your Bike Little e Kids Electric Balance Bike Unpowered training: It is possible to ride the bike with no power to begin with, in the same manner that you would ride a normal balance bike. To do this, follow the steps below 1.
-
Page 14: Maintaining Your Bike
Maintaining Your Bike Little e Kids Electric Balance Bike Brake adjustment: If the brakes do not perform as well as needed, you can adjust the brake cable tension in two places. The first place is on the brake lever on the handlebar (highlighted below). - Page 15 Maintaining Your Bike Little e Kids Electric Balance Bike Drum Adjustment: To adjust the cable tension at the drum end, first ensure that all cable tension at the brake lever is removed by winding the adjustment knob all the way into the lever as described above.
- Page 16 Maintaining Your Bike Little e Kids Electric Balance Bike 3. Charging the battery: First open the waterproof cover of the charging port found on the bottom of the battery, shown in the picture below. Plug the charger head into the charging port and plug the other end into your home power supply.
- Page 17 Maintaining Your Bike Little e Kids Electric Balance Bike 4. Adjusting the saddle height: When setting the seat height for the rider, it is crucial that the seat is never raised past the minimum insertion line on the seat post. If the post is raised higher than this minimum insertion line, it may cause irreparable frame damage or even rider injury.
- Page 18 Little e Kids Electric Balance Bike Lubrication is an important part of the maintenance of your Little e Kids Electric Balance bike. The table below shows the recommended maintenance schedule. Please note your nearest dealer will be able to carry this work out if you can not.
- Page 19 Maintaining Your Bike Little e Kids Electric Balance Bike Tips and Tricks 1. Do not drain the battery completely every time the bike is used. If the battery is subjected to this repeatedly, it will lose some of its capacity over time, decreasing its service life.