Garageio Blackbox Installation Manual

1 Door Installation
Thank you for purchasing Garageio!
Installation can be completed in as little as 15 minutes per door
and requires no special tools. You'll just need:
• A screwdriver
• A stepladder
• Masking tape
• Your Android phone, iPod Touch, or iPhone.
Step 1 of 9
Unpack the contents of your box
Your kit should contain the following:
A. Garageio Blackbox
Power Adapter
B.
Activator Package (containing 1 white activator and 4 screws)
C.
Opener Cable (red-banded, 6-ft long with black connector)
D.
Package of Adhesive-backed Cable Clips (containing 10 clips)
E.
F. Sensor Cable (green-banded, 32-ft long)
Step 2 of 9
Power up the Garageio Blackbox
• While inside of your home, plug the power adapter (Part B)
into the DC IN port on the Garageio Blackbox (Part A).
• The front light on the Blackbox will blink orange, and will
continue to blink orange as you connect your Blackbox to your
wireless network during the next step.
Questions?
Visit garageio.com/support to view solutions to the most common installation issues.
Step 3 of 9
Connect the Blackbox to your wireless network
•
•
•
ALCOHOL WIPE
(x4)
•
(x10)
Step 4 of 9
Install the Blackbox
•
Step 5 of 9
Connect the Blackbox to your opener
•
•
•
Download the iPhone or Android Garageio app. Open the
app, select "Setup Your Garageio," and connect your phone
to WiFi.
Select "Send BlinkUp" and hold your screen to the Blackbox
SETUP port for 10 seconds. The Blackbox's front light must be
blinking orange for BlinkUp to work.
TIP: If the Blackbox's front light is not blinking orange, restart
the Blackbox by toggling the power switch, and select the
"Clear Wireless Settings" option in the app.
Once BlinkUp is complete, the front light will flash green
several times while it connects to the Garageio service, then
turn off.
Enter your 16-character Blackbox code online at
garageio.com/verify to check that BlinkUp has been
successfully connected.
Mount the Blackbox to the side of your garage door opener
using the adhesive strips on the back of the Blackbox.
TIP: You can also mount the Blackbox to another surface
nearby (such as the ceiling or wall) using the tabs on the side
of the unit.
Locate the opener cable (Part D). Plug the black connector
into the Blackbox OPENERS port labeled 1.
Connect the other end of the opener cable to your garage
door opener. Use the provided cable clips (Part E) to secure
the wires.
View sample connection diagrams for your specific opener
model at garageio.com/opener.
PAGE 1