Advertisement
Product Specification
(Note 1)
Product Model
150 EX
Connecting Thread
1/2"PT (M)
Grease Cartridge Volume
150ml
Cycle Setting
0.5 to 12 months
Operating Temperature
-20°C to 60°C (-4°F to 140°F)
Push Force of Pressure Plate
5-150 psi . Automatically adjusts
(Piston)
according to the bearing's back pressure
Output Pressure
Under 10 bars . Prevents grease from
(Cup exit)
seeping through the shaft seal
Green: Normal operation
Single orange: Low battery
Indicator Lights
Double orange: Abnormal grease injection
Red: End of lubrication cycle
Product Size
15.7 x 8.35cm (6.18 x 3.28")
(height x diameter)
Rated Power (Battery Specification):
Easylube P-613A 6V x 1600 mAh , V0
Lubricant Refill (Lubricant Specification)
Easylube 1000 High performance grease cup
Easylube Service Pack
Easylube 1500 Multi-Purpose grease cup
Easylube 2000 Heavy-Duty grease cup
Easylube 5000 Food Grade grease cup
DIY empty grease cup
ATEX Hazardous
Locations Certification
DEMKO 20 ATEX 2227X
(Certificate Number)
Ingress Protection Code
IP66
EMC SGS Reference No.: MH/2020/10001C
CE Certification
RED SGS Reference No.: MH/2020/10002C
-
RoHS Certification
STEP 1
Take out old battery ,
remove empty grease
cartridge
STEP 4
Confirm dispensing
cycle setting
(Note 2)
II 3 G Ex ec IIC T6 Gc
Steps for Changing Service Packs
STEP 2
Reset press plate position
STEP 5
Insert new battery
Copyright
2020 Hornche Corporation. All Rights Reserved. Patents pending.
©
WARNING
Designated Service Packs
Please follow the technical specification
requirements of Easylube automatic
lubricators. In order to ensure the best
performance and the quality of Easylube
automatic lubricators, after the comple-
tion of each grease dispensing cycle, a
new grease cartridge and a new lithium
battery are required to be replaced.
Low Temperature Operation Instructions
The minimum operation temperature indicated in the product specification
represents the operation temperature of the lubricator. For actual operation,
the pumping performance of the selected grease and the stability of the
power source under low temperature environment need to be considered.
Application method of Oil
Please install Easylube automatic lubricator below the lubrication point
or install the special throttle valve / check valve at the outlet of the grease
cartridge during installation to prevent grease leakage.
Hazards and Safety Requirements
When using in hazardous areas, please adhere to the warnings on the
product label and follow the operating instructions. Electrostatic charges
may accumulate on the surface of the device and proper measures must
be taken to prevent electrostatic hazards.
Please ensure to dispose or recycle the replaced parts (grease cartridge
and battery) in accordance with the environmental protection policy stipulated
by local laws. Especially for the lithium battery, it is forbidden to be recharged,
dismantled, heated, burned, used outside the intended system, or discarded
into water or flame. These improper behaviors may cause toxic substances
to be emitted, which may harm human's health and cause environmental
pollution.
Note:
(1) The manufacturer reserves the rights to change the technical specifications without prior notice.
(2) 60 EX, 250 EX models are under development.
STEP 3
Install new grease cartridge
STEP 6
Confirm normal operations ,
observe grease is discharged
Rev Aug 2020
Advertisement
