Download Print this page
WARMWAVE HFQ15A Owner's Manual

WARMWAVE HFQ15A Owner's Manual

Advertisement

Available languages

Available languages

Quick Links

Fan Heater
Model: HFQ15A
PLEASE READ AND SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS
NOTE: When switching on the appliance for the first time, allow it to run at full power for
approximately two hours to get rid of the unpleasant odour. Make sure that the room in which the
appliance is located is well ventilated during this operation. It is normal for the appliance to emit small
cracking sounds when you turn it on the first time. Do not be alarmed.
When using electrical appliances, basic precautions should always be followed to reduce risk of fire,
electrical shock and injury to persons or property, including the following:
1.
Read all instructions before using this heater.
2.
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use
handles when moving this heater. Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes and curtains at least 3' (0.9 m) from the front and top of the heater and
keep them away from the sides and rear. Keep the rear grille away from walls or drapes so as not
to block the air intake.
3.
Extreme caution and supervision is necessary when any heater is used by or near children or
pets, and whenever the heater is left operating and unattended.
4.
Always unplug heater when not in use.
5.
Do not operate any heater with a damaged cord or plug or after the heater malfunctions, or has
been dropped or damaged in any manner. Return the heater to an authorized service facility for
examination, electrical or mechanical adjustment, or repair.
6.
Do not use attachments or filters. They are not recommended.
7.
Do not use outdoors.
8.
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.
Never locate heater where it may fall into a bathtub or other water container.
9.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners or similar coverings.
Arrange cord away from traffic area and where it will not be tripped over.
OWNER'S MANUAL
IMPORTANT INSTRUCTIONS

Advertisement

loading

Summary of Contents for WARMWAVE HFQ15A

  • Page 1 Fan Heater Model: HFQ15A PLEASE READ AND SAVE THESE INSTRUCTIONS OWNER’S MANUAL IMPORTANT SAFEGUARDS NOTE: When switching on the appliance for the first time, allow it to run at full power for approximately two hours to get rid of the unpleasant odour. Make sure that the room in which the appliance is located is well ventilated during this operation.
  • Page 2 10. To disconnect the heater, turn control to OFF, then remove the plug from the outlet. 11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage to the heater. 12.
  • Page 3: Pilot Light

    PARTS OF THE HEATER Parts of the heater 1. Thermostat Control 2. Pilot Light 3. Power Control 4. Safety Grille Symbols Power Off Fan Only Low Heat Setting High Heat Setting OPERATING INSTRUCTIONS 1. Set the heater on a dry, level surface. 2.
  • Page 4: Manual Del Propietario

    Calefactor Modelo: HFQ15A POR FAVOR LEA Y GUARDE ESTAS INSTRUCCIONES MANUAL DEL PROPIETARIO IMPORTANTES MEDIDAS DE SEGURIDAD NOTA: Al encender el electrodoméstico por primera vez, déjelo funcionando en toda su potencia durante aproximadamente dos horas para deshacerse del olor desagradable. Asegúrese de que la habitación en la cual se encuentra el electrodoméstico esté...
  • Page 5 10. Para desconectar el calefactor, apague el control de encendido en (OFF), luego quite el cable del tomacorriente. 11. No inserte ni permita que objetos extraños ingresen en ninguna ventilación u orificio de salida ya que esto podría causar una descarga eléctrica, incendio o daño al calefactor. 12.
  • Page 6: Limpieza Y Mantenimiento

    PARTES DEL CALEFACTOR Partes del calefactor Símbolos 1. Control Termostático Apagado 2. Control de Encendido Sólo Ventilación 3. Luz Piloto Configuración para Calor Bajo 4. Parrilla de Seguridad Configuración para Calor Alto INSTRUCCIONES DE FUNCIONAMIENTO 1. Coloque el calefactor sobre una superficie seca y nivelada. 2.