Advertisement
Quick Links
PLEASE READ ALL INSTRUCTIONS BEFORE
ATTEMPTING TO INSTALL WALL MAP
INSTRUCTIONS ON HOW TO MOUNT WALL
MAPS SHOULD BE FOLLOWED TO PREVENT
DAMAGE (failure to carefully follow these
instructions could void product warranty)
WALL MAP(S) AND SPRING ROLLER NEEDS TO
BE ATTACHED TO BACKBOARD PRIOR TO
MOUNTING ON WALL
Kappa Map Group
Version 4.0
Advertisement
Summary of Contents for Kappa Map Group Wall Map
- Page 1 INSTRUCTIONS ON HOW TO MOUNT WALL MAPS SHOULD BE FOLLOWED TO PREVENT DAMAGE (failure to carefully follow these instructions could void product warranty) WALL MAP(S) AND SPRING ROLLER NEEDS TO BE ATTACHED TO BACKBOARD PRIOR TO MOUNTING ON WALL Kappa Map Group...
- Page 2 To prevent damage, use care when removing wrapping materials to avoid cutting into Wall Map(s). Wall Map(s) should NOT be pulled down beyond the point where full image is displayed and/or the sticker stating DO NOT PULL PAST THIS POINT which is...
- Page 3 Step 2: Take Wall Map(s) mounted on spring roller and insert the rectangle end into the backboard side bracket you have just attached to the backboard. BE CAREFUL NOT TO TURN OR APPLY PRESSURE TO THE RECTANGLE END OF ROLLER WHILE PLACING INTO SIDE BRACKET.
- Page 4 Fill holes with lead screw shields, size 1/8" x 1". Due to weight of Wall Map(s) and backboard you may want to use wall anchors to better secure Wall Map(s) and backboard to wall for safety and long-term usage of these products.
- Page 5 If your Wall Map contains 1 or 2 maps attached to spring roller and backboard, this is the backboard mounting bracket that should be used for mounting purposes: If your Wall Map contains 3 or more maps attached to spring roller and backboard, these...
- Page 6 Wall Maps Containing 3 or more maps: Requires 2 backboard mounting brackets and final placement roughly one foot inside each end of the wall map backboard (EXAMPLE: If your Wall Map is 6 feet wide, the backboard mounting brackets should be roughly 4 feet apart).
- Page 7 Step 4: How to use Wall Map(s) after installation: Always pull your Wall Map(s) down from the center of its bottom edge. Never pull a Wall Map(s) down by its corner nor pull beyond the point where full image is displayed. Wall Map(s) may have a sticker, near the top of the image, indicating STOP so not to pull down beyond point indicated.
- Page 8 AND LOCKED INTO PLACE BEFORE STARTING PROCESS. 1. Remove the Wall Map(s) and backboard from the wall by sliding it out of the backboard mounting bracket(s). Then remove the side bracket (side bracket with rounded hole) from the backboard by...
- Page 9 2. Inspect each end of the roller. On one end, you will observe a round stationary post and on the other end, you will notice a flat post that can be turned. 3. The flat post end has a gear type mechanism that is hidden within the roller. This is the end that needs to be re-sprung.