Advertisement
Quick Links
STEPS FOR ASSEMBLING INTERLINK 6
Swing cover from side of foot to
5
Place either jet
pack (they are
interchangeable)
into RL3's left
shoulder hole
8
The inner
ankle
shields are
to be
pegged to
the opposite
hip hole. Lift
torso armor
to enable
you to
connect the
to shields
together
ASSEMBLY
INSTRUCTIONS PAGE 1
Connect RL3 legs
1
together by two pegs
2
front and peg into hole
6
Remove LL4's
rear guard and
unplug the
hoses
The shields connect together under
9
the armor. The shields also peg
together in the back
3
Remove
both arms.
4
Remove
jet packs
from back
7
Remove ankle
shields, knee
shield and
connector for
each leg
10
NOTE:
Removed
parts may
be used at
different
stages of
assembly.
Move outer ankle shields up to
thighs, then plug rear guard tabs
and pegs into shield slots and
holes
Advertisement
Summary of Contents for SPAWN interlink 6
- Page 1 ASSEMBLY INSTRUCTIONS PAGE 1 STEPS FOR ASSEMBLING INTERLINK 6 NOTE: Connect RL3 legs Removed parts may together by two pegs Remove be used at both arms. different stages of assembly. Swing cover from side of foot to Remove front and peg into hole...
- Page 2 ASSEMBLY INSTRUCTIONS PAGE 2 STEPS FOR ASSEMBLING INTERLINK 6 - C O N T I N U E D Rear guard hoses peg into back Fold of feet arms behind Remove back hand, slide arm gun off, then reattach hand.
- Page 3 ASSEMBLY INSTRUCTIONS PAGE 3 STEPS FOR ASSEMBLING INTERLINK 6 - C O N T I N U E D HD1’s foot plates have a loop at the end that attaches to hooks at There are two T-pins on the back...
- Page 4 ASSEMBLY INSTRUCTIONS PAGE 4 STEPS FOR ASSEMBLING INTERLINK 6 - C O N T I N U E D Press feet Remove together and right arm insert peg and head into hole Peg right arm into head hole CONNECTING ≥...
- Page 5 ASSEMBLY INSTRUCTIONS PAGE 5 STEPS FOR ASSEMBLING INTERLINK 6 - C O N T I N U E D Peg the Take one lower leg shield and peg shield into holes on front side. Repeat on that Turn out legs at...
- Page 6 ASSEMBLY INSTRUCTIONS PAGE 6 STEPS FOR ASSEMBLING FUELING STATION FOR INTERLINK 6 Take the long uprights and plug into base Place right base piece onto left base piece to connect C O N N E C T I N G ≥...
- Page 7 ASSEMBLY INSTRUCTIONS PAGE 7 Gun from LL4 Mask from LOCATION OF REMAINING PARTS Neck guard from LA6 Front shield from back shield from RL3 FRONT VIEW LEFT SIDE VIEW Helmet from LL4 Forearm pad Gun turrets from from HD1 cover from Kneecap covers...
- Page 8 ASSEMBLY INSTRUCTIONS PAGE 8 INDIVIDUAL ROBOT Proceed to peg ASSEMBLY for pod/antenna assemble to shoulder guard cover. Larger two pegs attach to After removing robot from HD1’s left side and smaller packaging you will need to pegs go to right side. attach each 8”...
- Page 9 ASSEMBLY INSTRUCTIONS PAGE 9 INDIVIDUAL ROBOT Load missile into hole on right forearm pad. ASSEMBLY for Pull back and release to fire Helmet Mask clips snaps onto back into hooks Shoulder shields collar plugs into holes above arms INDIVIDUAL ROBOT Pivot trigger up and down to move ASSEMBLY for chainsaw blades...
Need help?
Do you have a question about the interlink 6 and is the answer not in the manual?
Questions and answers