Summary of Contents for PlastGrommel CornerRounder
- Page 1 CornerRounder www.plastgrommet.com Instructions for 1x Allen wrench #3 & CornerRounder CornerRounder Kit 1x Alignment tool 1x Upper holder + 3/8” Radius blade (10 mm) 1x Lower holder + cutting pad Ref: PHTIKCR10...
- Page 2 Place the upper holder. Remove the safety device Align the upper holder with the HPS025 of the blade. and fix its position, tightening the grub screw of the upper holder. Loosen the screw of the cutting pad from the lower holder.
- Page 3 When the alignment from step 7 is done, Tighten the screw of the cutting pad. tighten the lower grub screw from the HPS025 to fix the lower holder. Put the alignment tool on the body of the Holding the lever, loosen the grub screw to leave the lever in the starting position.
- Page 4 Do you have this problem? Loosen the screws that fix the guide brackets. Press and keep the lever down, making the blade come in contact with the cutting pad; then tighten the upper grub screw from the HPS025 to leave the lever blocked. Push the alignment tool against the blade.
Need help?
Do you have a question about the CornerRounder and is the answer not in the manual?
Questions and answers