Summary of Contents for PalmerHamilton Nomad Re-Load Mobile Table with Charging Station
Page 1
Operational Manual 12V DC Power Source Mobile Table with Charging Station for “Re-Loading” Mobile Devices WARNING READ THIS ENTIRE MANUAL BEFORE OPERATING THIS TABLE. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY, DAMAGE TO THE CHARGING DEVICES AND THE TABLE. Re-Load Instructions RevD Toll Free: 800-788-1028 •...
Table of Contents SECTION PAGE 1. Re-Load Parts Schematic 2. Safety Instructions 3. Personal Precautions 4. Charging the Re-Load Battery Pack 5. Using your Re-Load 6. Discharging of Battery 7 . Removing Internal Battery 8. Table Base 9. Work Surface & Charging Hub 10.
Page 3
Important: Read and save this safety and instruction manual SAVE THESE INSTRUCTIONS-- Charge the internal battery in Re-Load immediately after receiving the table. You should charge the Re-Load battery monthly when not in use. This manual will show you how to use the Re-Load safely and properly. Please read and follow these instructions and precautions carefully, as this manual contains important safety and operating instructions.
2. Important safety instructions 2.1 Only use connections from Palmer Hamilton. Use of any other brand of connections other than by Palmer Hamilton may result in a risk of fire, electric shock, injury to person or property, and void of warranty. 2.2 DO NOT allow the internal battery of the Re-Load table to freeze.
3. Personal precautions 3.1 Never smoke or allow a spark or flame within five feet of the Re-Load battery. 3.2 To reduce the risk of shock, first unplug the charger from the wall outlet then disconnect all connections on the interior of the battery compartment. 3.3 Remove personal items such as rings, bracelets, necklaces and watches when working with a lead-acid battery.
4. Charging the Re-Load table battery pack IMPORTANT: CHARGE THE INTERNAL BATTERY IMMEDIATELY AFTER RECEIVING YOUR RE-LOAD TABLE. IF NOT IN USE, CHARGE MONTHLY TO MAINTAIN THE FULL BATTERY LIFE. *SELF-CHARGING RE-LOAD TABLES (SC) WILL INCLUDE A CHARGER IN THE BATTERY COMPARTMENT.
5. Using your Re-Load “RELOAD” YOUR MOBILE DEVICES — ASSUMING NO OTHER CONNECTIONS ARE MADE 5.1 Align “A” wire connector with “C” wire connector 5.2 Gently push connection together. 5.3 Charging Hub should be lit BLUE (If the LED is RED more charging may be needed). 5.4 Slowly close the worksurface down making sure all wires are kept inside battery compartment and not in the way of getting pinched.
6. Discharging of battery 6.1 As mobile devices get “Reloaded” from the charging hub, the battery will begin to slowly discharge. 6.2 When the BLUE LED is lit, this means the internal battery power status is in the range from 100% to 10%. 6.3 When the RED LED is lit the battery power status is below 10% and needs to be charged.
8. Table base 8.1 The Re-Load table base consists of two parts, Upper Welded Assembly and Lower Welded Assembly (X-base). 8.2 The Lower Welded Assembly portion is held in place with machine screws and star washer. Regularly inspect this connection. To do so; slowly tip table onto its side, exposing the access hole on the bottom of the Lower Welded Assembly.
10. Storage 10.1 If the Re-Load table will be stored for a considerable amount of time, please charge the internal battery fully. 10.2 All batteries are affected by temperature. The ideal storage temperature is 70°F . The internal battery will gradually self-discharge (lose power) over time, especially in warm/cold environments.
11. Troubleshooting Problem Possible Causes Reason/Solution Battery and Charging Hub may not Access battery compartment and My device won’t “Reload” be connected correctly connect “B” and “C” wires together Access battery compartment and Battery might be discharged and will attach battery to charger (4-5 hours need to be charged before ready) Device charging cord could be...
12. Limited Warranty Limited Warranty Palmer Hamilton, LLC, warrants this product will be free from defects in material and workmanship under normal use for a period of one (1) year from the date of original purchase on the Charging Hub and Battery; and a period of five (5) years on the table base and worksurface.
Page 14
143 S. Jackson Street Elkhorn, WI 53121-1911 Toll Free: 800-788-1028 Local: 262-723-8200 Fax: 262-723-5180 www.NomadFlexibleFurniture.com To see the complete family of Palmer Hamilton products please see www.palmerhamilton.com...