Summary of Contents for Wally Rebounder Double Bounder
Page 1
DOUBLE BOUNDER SETUP INSTRUCTIONS Introduction Setting up your Double Bounder is a little more involved than setting up a single Wally Rebounder. If you are a new user, we suggest setting up a single board configuration first and getting used to the product before assembling the full double bounder.
Page 2
Begin by setting up a single board, only this time you will be attaching the double bounder bracket to what will become the middle tripod. You can set the board on a corner of the table to help hold it in place as shown. A tripod...
Page 3
In this configuration you may prefer to attach the double bounder bracket to the boards using the middle holes in the bracket instead of the end holes as this produces a smaller gap between the boards.