Table of Contents
Advertisement
Quick Links
Boss Water Systems
Australia
Reverse Osmosis System
Model – 021-4PC
Congratulations on your purchase of the
most advanced water purifier system
available!
Installation and Service Guide short web version,
this is not the instruction manual you will receive
with your purchase of a PSI-021-4PC but a shortened
version that is available on our web site, it is a
shorter version due to other suppliers likely to copy
this instruction manual as their own.
This system is designed to also remove ammonia which a normal reverse osmosis
system can't do as the ammonia is introduced into the water as a gas not a liquid
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Boss Water Systems 021-4PC
Summary of Contents for Boss Water Systems 021-4PC
- Page 1 Installation and Service Guide short web version, this is not the instruction manual you will receive with your purchase of a PSI-021-4PC but a shortened version that is available on our web site, it is a shorter version due to other suppliers likely to copy this instruction manual as their own.
- Page 2 Waste Water The PSI-021-4PC is designed for simple installation and operation and is well within the abilities of a home handyman to maintain, the filters should be changed at the recommended service intervals to maintain continual un-troubled service life.
- Page 3 Caution This Reverse Osmosis system is designed for operation on microbiologically safe water which is usually Chlorinated mains water supplies, this system is not suitable for installation on Un-Chlorinated water supplies, contact your selling agent to have a UV steriliser added for microbiologically unsafe water such as Tank, Dam or Bore water. Pressurised Storage Tank Pressure gauge to read...
- Page 4 Stage 3 This is the membrane which is the main filter in a reverse osmosis system, pore size is less than 0.0005 micron, the membrane is a thin film composite, NSF stand 42, 53 and 58, normal replacement is usually between 3 to 5 years. Stage 4 This is the carbon polishing post filter which provides final filtration to provide superb tasting clean water.
- Page 5 Determine desired location for the faucet on your sink surface. Place a piece of masking tape or duct tape on location where the hole is to be drilled. Mark the centre of the hole on the tape. Using a variable speed drill on the slowest speed, drill a 1/8” (3 mm) pilot hole at the centre of the desired location.
- Page 6 Flush valve maintenance. This unit is fitted with a membrane-flushing valve and is normally closed. About once a month Turn the Faucet on and drain the tank, at the same time turn the small red or blue valve at the front of the unit to the open position and leave it on for about 10 minutes to clear any possible build-up of particles, failure to do this will shorten membrane life.
Need help?
Do you have a question about the 021-4PC and is the answer not in the manual?
Questions and answers