Download Print this page

Saunum H-1/6 Instructions For Use And Installation

Climate system devices for saunas

Advertisement

Quick Links

1

Advertisement

loading

Summary of Contents for Saunum H-1/6

  • Page 2 Saunum’s climate system devices H-1/6 and H-1/9 for saunas Instructions for use and installation...
  • Page 3 Saunum H-1/6 and Saunum H-1/9 An EC declaration of conformity certifies that the products Saunum Premium Set H-1/6 and Saunum Premium Set H-1/9 are in compliance with the requirements of the following directives of the Council of Europe, provided that the installation has been conducted...
  • Page 4 Saunum Saunas LTD. congrats you on choosing an innovative sauna climate device!
  • Page 5: Safety Information

    This installation and operation manual is intended for the owner or caretaker of a sauna as well as for the electrician responsible for installing the climate system device. After installing the sauna climate device, the manual must be handed over to the owner or caretaker. The Saunum’s Sauna Climate Device H-1 (hereafter referred to as ‘the sauna climate device’) shall not be put into operation until the installation and safety instructions have been read.
  • Page 6 NB! Attention! Before switching on the sauna climate device, always make sure that there is nothing above or near it!!! The temperature and operating time of sauna climate device model Saunum H-1 are controlled by a separate control module. • DIRECT CONNECTION OF THE DEVICE TO THE POWER NETWORK IS PROHIBITED! •...
  • Page 7 1.2.1. Adjusting the temperature NB! It is advisable to keep the air circulation fan of the sauna climate device off while you are heating up the sauna room! In this case, the sauna heats up faster and at the same time, the bench does not become hot. You can find the best setting for you by experimenting. Start testing at lower temperatures and minimum airflow rates.
  • Page 8 The air in the sauna becomes dry when heated. Therefore, you need to throw water on the rocks to achieve the suitable humidity level. The effects of heat and steam on people are different, testing the different settings of the SAUNUM’s sauna climate device will help you find the right combination of temperature and humidity.
  • Page 9 • Consult your doctor about any medical contraindications to sauna bathing. • Consult your doctor for medical contraindications to salt treatments. Make sure you are not allergic to salt therapy. Saunum is not responsible for the side effects of salt treatments.
  • Page 10 The steam room warms up slowly. The water thrown on the stones quickly cools them down. • Make sure the air circulation fan of the sauna climate device is switched off during the warm-up time. • Make sure that the fuses in the sauna climate device are in working order. •...
  • Page 11 Noises are coming from the sauna climate device. • There is always a certain sound when the fan is running. If it is not smooth and/or has a metallic rumble, the fan will probably need service or repair. Check the fan’s air vents for foreign objects. Try switching the fan to a lower speed. •...
  • Page 12: Sauna Room

    10 m³ sauna room with a glass door corresponds to the capacity requirements of a 12 m³ sauna room. If the sauna room has log walls, multiply the volume measure by 1.5. The optimal size of the sauna for the Saunum PREMIUM Set H-1 is given in Table 1 (page 16). The height of the sauna is usually 2100...2300 mm.
  • Page 13: Installation Instructions

    The power for the device must be taken from the power circuit of the control device, which is protected by overcurrent fuses. The required sizes of overcurrent fuses and connection cable dimensions are given in Table 1 (page 16). All certified sauna controller devices with the sufficient capacity for the Saunum H-1 model in accordance with Table 1 (page 16) can be used to control the sauna climate device.
  • Page 14 3.3. Electrical connections The electrical connection of the device must be installed by a qualified electrician in accordance with applicable standards and requirements. • The connection of the sauna climate unit must be done semi-stationarily on the wall of the steam room of the connection box. The junction box must be splash-proof and have a maximum height of 500 mm from the floor.
  • Page 15 DRAWING max 2100mm Figure 3.1: Premium sauna climate system overall dimensions...
  • Page 16 DRAWING Volume Sauna device 5-9 m Saunum H-1/6 min. 50mm min. 75mm 8-15 m Saunum H-1/9 min. 50mm min. 100mm The safety distances of the sauna climate device and the recommended location in the steam room...
  • Page 17 DRAWING TEMPERATURE SENSOR (LOCATION ACCORDING TO THE MANUFACTURER`S REQUIRMENTS) CONTROL PANEL CAT6 0,34mm Optional ! Connecting the fan directly from the electric panel if adjustment from the HEATING control panel is not recommended. ELEMENTS DOOR SENSOR 3 x 1,5 0,34mm (OPTIONAL) 5 x 2,5 CONTROL UNIT...
  • Page 18 SAFETY DISTANCE SAUNA ROOM DEVICE OUTPUT 3 phase/1 phase 3 phase/ 1phase /fan FROM THE HEATER CUBIC VOL. m from side 50mm, Saunum H-1/6 3x10A/1x35A 5x2,5/3x6 /3x1,5 5 - 9 front 75mm from side 50mm, 8 - 15 Saunum H-1/9 3x16A/1x50A...
  • Page 19 FIGURES Figure 3.2: Removing the flue socket Figure 3.3: Installing bolts for middle mounting holes...
  • Page 20 FIGURES 4x M6 Figure 3.4: Hanging the sauna climate device on the wall Figure 3.5: Installing the upper and lower mounting bolts and fixing the sauna climate device to the wall...
  • Page 21 FIGURES Figure 3.6: Installation of flue socket on the device and fastening Figure 3.7: Fitting and fastening the flue cap with screws...
  • Page 22 FIGURES Figure 3.8: Fitting the flue to the flue socket and hanging it to the flue cap...
  • Page 23 FIGURES Figure 4: Opening electrical panel...
  • Page 24 FIGURES Figure 5: Opening himalayan salt ball shelf...
  • Page 25 FIGURES Placing heating element supporting rods and placing stones in the stove...

This manual is also suitable for:

H-1/9