Ceramicx HERSCHEL ADVANTAGE PULSAR APW/0416 Installation Instructions

HERSCHEL ADVANTAGE
PULSAR WHITE
Ceiling - mounted Infrared Heaters
(ceramic elements)
Installed ceramic heaters are
UL recognised (file no. E214574)
APW V1.6 230516
ORIGINAL INSTALLATION & OPERATING INSTRUCTIONS
The Pulsar consists of 4 highly emissive ceramic heating elements contained within a coated mild steel housing. It is designed to gently
warm people using infrared heat.
Infrared Heat is a 100% natural radiating heat that humans readily absorb, producing a feeling of great comfort and well-being. Infrared
Heat produced from the Pulsar warms you directly without heating the air in between, meaning the heat goes where you want it to and
doesn't disappear on the next puff of wind.
CAUTION:
The Pulsar rises to very high temperatures in use and the unit must not be touched when power is applied. After switch off the surface
temperature will remain hot for a considerable time and the unit should not be touched within 30 minutes minimum after heater has been
switched off.
Please attach the supplied notice (CAUTION DO NOT TOUCH HEATER) to the wall near the heater or in a location where it can easily be seen.
Never use the heater to ignite materials.
Particular attention has to be given where children and vulnerable people are present. The Pulsar is not to be used by children or persons with
reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given instruction or are under
supervision. Children of less than 3 years should be kept away unless continuously supervised. Children should be supervised to ensure they
do not play with the appliance.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
To avoid a fire hazard, do not cover the heater in any manner and ensure there is adequate air circulation around the heater. The Appliance
shall, under no circumstances, be covered with insulating material or similar material.
The heater must not be used if the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
WARNING:
This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by
persons not capable of leaving the room on their own, unless constant supervision is provided.
IMPORTANT INFORMATION:
Please read the following information fully, as safe and reliable operation depends on correct installation. Please keep this instruction sheet
for future reference.
The AC mains supply is dangerous and potentially lethal. Ensure the mains supply is switched off at the consumer unit (fuse box) before
attempting any work on electrical circuits. Wiring to this unit must be connected in accordance with the relevant national electrical safety
standards. This unit must only be installed by a competent and qualified electrician. This appliance must be earthed.
Do not disassemble : no user-serviceable parts inside.
ELECTRICAL INFORMATION:
The electrical supply to the unit should be provided by connecting to a circuit, which is protected by a fuse or miniature circuit breaker
suitable for the electrical rating of the unit and in accordance with Table 1. The supply to the heater must be switched separately using a
switch appropriately rated for the load and supply voltage. A switched fused spur may also be used on existing ring main circuits where the
MODEL: APW/0416
APW V1.6 260416 Page 1