Hobby Components HCRFID0002 Manual

RFID Access Control Panel
Manual
HCRFID0002
Product Specification
Voltage: 12VDC+10%, Current 1.2A
Lock Relay: 12VDC/2A
Environmental Temperature: working:0℃~45℃;
storage:-10℃~55℃
Relative humidity: working: 40%~90%RH;
storage: -20%~90%RH
Card Capacity: 1000
PIN Capacity: Public PIN: 1 Private PIN:500
Internal Reader Frequency: ID model:125KHz
ICmodel: 13.56MHz
Proximity Card: ID model: EM or compatible
IC model: Mifare1 or compatible
Card Reading Distance: ID model:5 - 15CM
IC model: 3 - 5CM
Lock interface: Relay output or level output
Exit Button: One interface
Bell: One interface
Door contact: One interface
Alarm Interface: One level output
Factory Defaults
Programming Pin: 990101
Door Open Mode: Card or public (1234)
Private Pin: 0000
©Hobby Components Ltd
Door Open Time: 3 Seconds
Anti-Break Alarm: Disabled
Door Contact Alarm: Disabled
Lock Status: Disabled
Alarm Delay: 0 Seconds
Modify Private Pin: Disabled
LED & Buzzer
Normal mode:
Valid command: Short beep
Invalid command: Long beep
Programming mode:
Green LED on
Valid command: Two short beeps
Invalid command: Three beeps
Cancel Command
Press the [*] key to cancel command.
Functions and Setup
Enter the programming mode
Press [*]+[6-digit pin] (Default is 990101)
Modify the programming pin
Press [0]
+[new 6-digit pin]
+[confirm the new 6-digit pin]
Enroll card
Press [5]
+[3-digit index code] (2 beeps)
+[Card1] (beep, 2 beeps)
+[Card2] (beep, 2 beeps)
+......
+[Cardn] (beep, 2 beeps)
+[*] (2 beeps)
3-digit index code: range from 001-500. Card can be deleted
by this code.
When enrolling multiple cards, every card index code will be
calculated in order. For example, card one's index code is 15,
card two's will be 16.
The default private pin for each card is 0000
Delete card
Delete by index code
Press [7]
+[3-digit code1] (2 beeps)
+[3-digit code2] (2 beeps)
+......
+[3-digit coden] (2 beeps+[*](2 beeps)
Delete by presenting card
Press [7]
+[Presenting Card1] (beep, 2 beeps)
+[Presenting Card2] (beep, 2 beeps)
+......
+[Presenting Cardn] (beep, 2 beeps)
+[*] (2 beeps)
Delete all cards
Please restore the factory default
The private pin will be deleted when the card is deleted
Exit programming mode
Press [*] (2 beeps)
Set up door open mode
Card or pin mode
Press [1]+[0] (2 beeps)
Card + private pin mode
Press [1]+[1] (2 beeps)
PINs
The pin in "Card or PIN" mode is either the public pin or
private pin (at most 500).
Disable changing private pin
Press [1]+[2] (2 beeps)
Enable changing private pin
Press [1]+[3] (2 beeps)
Change private pin
Press [＃] (2 beeps)
+[Presenting card] (beep,2 beeps)
+[4-digit old pin] (2 beeps)
+[4-digit new pin]
+[confirm the new pin] (2 beeps)