LiteShelf Inset Use And Care Manual

When using an electrical furnishing, basic precautions should always be followed, including the
following:
Read all instructions before using (this furnishing).
DANGER
- To reduce the risk of electric shock:
1. Always unplug this furnishing from the electrical outlet before cleaning.
WARNING
- To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Unplug from outlet before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is used by, or near children, invalids, or
disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
4. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return the furnishing to a service center for
examination and repair.
5. Keep the cord away from heated surfaces.
6. Never operate the furnishing with the air openings blocked. Keep the air openings free of lint, hair,
and the like.
7. Never drop or insert any object into any opening.
8. Do not use outdoors.
9. Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
10. To disconnect, turn all controls to the off position, then remove plug from outlet.
WARNING
: Risk of Electric Shock - Connect this furnishing to a properly grounded outlet.
To reduce the risk of electric shock, this furnishing may have a polarized plug (one blade is wider than
the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not
change the plug in any way.
11. For loading always put heavier items at the bottom and not near the top in order to help prevent the
possibility of the furnishing tipping over.
PREPARING FOR INSTALLATION
A) This shelf is not intended for installation in an aquarium.
B) Be sure to keep the power supply clear of the shelf during installation.
C) Do not make any physical changes to LiteShelf Inset before or after installation.
D) LiteShelf Inset is designed only for indoor installation.
E) Not following these instructions can result in personal physical injury, and will void the warranty.
INSTALLATION
A) Place LiteShelf Inset into position to check for fit.
B) Remove LiteShelf Inset, and plug the Power Supply into the wall
C) Clean mounting area with included alcohol wipes before installation EVEN IF IT LOOKS CLEAN.
D) Wait 2 minutes for the alcohol to evaporate.
E) Plug the power supply into LiteShelf Inset. The power jack is usually located on the left-rear of the shelf
approximately 3 inches in.
F) Remove red backer tape
LiteShelf Inc . www.LiteShelf.com
LiteShelf Inset
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
. 544 Park Avenue, #209, Brooklyn, NY 11205 .
Use and Care guide
Info@LiteShelf.com . 732-74-Shelf