Advertisement
How to use:
Step 1: Insert batteries into the camera
The very first step before you even touch the film is to insert a fresh set of AA alkaline batteries
of the same brand into the camera.
The battery compartment, which opens and closes via a sliding battery lid, can be found on the
right side of the camera. The lid can be a bit difficult to unlock at first but it does loosen up over
time.
Step 2: Remove film from the package
Next we have to remove the film from the packaging. As you do so, make sure not to touch the
two rectangular holes on the back as you will damage the film. It is also important to avoid direct
sunlight when loading the film pack into the camera.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for instax Mini 9
- Page 1 How to use: Step 1: Insert batteries into the camera The very first step before you even touch the film is to insert a fresh set of AA alkaline batteries of the same brand into the camera. The battery compartment, which opens and closes via a sliding battery lid, can be found on the right side of the camera.
- Page 2 In one corner, you’ll notice there is a yellow mark – make a note of it as it is important for the next step! Note: If you notice that the film is beyond its shelf life, it is best not to use it as expired film can damage the camera.
- Page 3 Place the film inside the camera by aligning the yellow marks. If you load it any other way, you risk damaging the film or even worse, the camera!
- Page 4 Finally, close the back cover and make sure the lock clicks into place. Step 4: Eject the film cover Before you can take your first Instax photo, there’s one final step!
- Page 5 On the rear, you’ll notice that the film counter display (the number of shots remaining) is set to S. This is because you still have to eject the black film cover. To do this, simply turn on the camera by pressing the large button located directly beside the lens and press the shutter button.
- Page 6 …to turn the camera on. Press the shutter button… …and pull out the film cover. Gently remove the film cover, grasping it by the edges. The film counter display will now show 10 instead of S, which means you’re reading to start shooting!
- Page 7 Helpful Tips and Tricks: Once you’ve loaded the film, do not open the rear compartment again until you’ve used up all your shots. Doing so will expose the rest of the film, making it unusable. Do not cut or peel apart new or newly used film. The small amounts of caustic paste contained within the film can cause an alkali burn.
Need help?
Do you have a question about the Mini 9 and is the answer not in the manual?
Questions and answers