Relaxa CRM2015 Instruction/Technical Manual

Bath lift

Advertisement

Quick Links

INSTRUCTIONS & TECHNICAL MANUAL
BATH LIFT
MODEL CRM2015
Important safety information.................. 2
The product ......................................... 3
The battery and charger ........................ 3
Temperature gauge and probe ................ 4
Hand held controller .............................. 4
BATH LIFT
INDEX
Operation ............................................. 4
Indicator lights ..................................... 6
Maintenance ........................................ 6
Installation........................................... 7
Wall Mounting the unit .......................... 7
MADE IN UK
Floor Anchor Fixing ............................... 8
CE and EMC Approved ........................... 8
Environmental Information .................... 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CRM2015 and is the answer not in the manual?

Questions and answers

Summary of Contents for Relaxa CRM2015

  • Page 1: Table Of Contents

    INSTRUCTIONS & TECHNICAL MANUAL BATH LIFT BATH LIFT MODEL CRM2015 INDEX Important safety information....2 Operation ..........4 Floor Anchor Fixing ....... 8 The product ......... 3 Indicator lights ........6 Contained in your delivery carton ... 8 The battery and charger ......3 Maintenance ........
  • Page 2: Important Safety Information

    The battery charger must not be used in the bathroom. The battery weighs 1.5 kg (3.3 lbs) and should be handled carefully. IMPORTANT SAFETY Keep the battery well charged. INFORMATION The belt must be located in the floor anchor correctly. Make sure the It is important this instruction manual retaining discs prevent the belt from is retained with the bath lift for future...
  • Page 3: The Product

    THE PRODUCT THE BATTERY AND BATTERY CHARGER The bath lift is a motorised device designed Following the installation the battery for the use of the elderly and those who should be charged for a minimum of find that getting into and out of a bath has 15 hours.
  • Page 4: Temperature Gauge And Probe

    TEMPERATURE GAUGE AND PROBE OPERATION The probe is located on the bottom right With the battery fully charged and the hand side of the unit. The probe has a temperature probe in position the bath lift small plastic disc attached and should be can be used.
  • Page 5 STEP 4 STEP 6 By rotating the discs the anchor bar can be The bath lift is now ready for the bather to sit located into the mounting bar itself. Turn the on the belt, ease their legs over the side of discs to ensure the anchor bar is positively the bath and into the water holding on to the locked in.
  • Page 6: Indicator Lights

    STEP 8 off the button the screen will show the temperature of the water. When bathing is finished press the UP button and this will raise and return the user back to the original bath height, so that the bather can again hold on to the grab rail and place their feet over the bath edge and onto the floor.
  • Page 7: Installation

    When showering, care must be taken to The chassis backplate is machined with 6 avoid soaking the unit with an excess of keyhole slots which allow this steel plate to slot water which could damage the interior tightly down over the projecting studs. Both electronics.
  • Page 8: Floor Anchor Fixing

    We support the reuse or reselling of our products which are yet to reach the end of their useful 1 Kites Park, life. Re-using the Relaxa bath lift not only extends the product life-cycle of the bath lift but Summerleys Road, minimises its environmental impact.

Table of Contents