Sandman Mini HotDialer Manual

Download this manual

Instructions for Installing & Programming the Mini HotDialer™

Install the Mini HotDialer™ dialer as shown in the picture below, if it's not pre-installed in a phone.

The Mini HotDialer™ only works on standard analog telephone lines, analog station ports and analog telephones.

The Mini HotDialer™ is telephone line powered and has non-volatile memory so it will not lose its programming when

unplugged from the phone line.

Program Quick Reference:

To Enter Programming:

Lift the telephone handset and dial the default programming password: XXX You'll hear one beep. You are now in

programming mode and can enter any valid program Register.

If you enter the password incorrectly you won't hear the one beep, and you'll have to hang up the phone for the amount

of time programmed in Register 16 (800ms by default). Then lift the handset again and enter the program password

correctly.

To exit programming dial 99, wait for a beep, and hang up.

If you have previously programmed the Mini HotDialer™ to dial when the handset is lifted you will have to wait for it

to finish dialing before entering program mode!

If you hear 4 beeps this means a program entry was incorrect.

Programming:

Steps in programming the Mini HotDialer™:

1. Enter programming mode (see above)

2. Dial the Register number (like 01 from the above list) and you will hear 1 beep

3. Dial the program data

4. Dial # # to save the Register entry you just programmed, and you'll hear 2 beeps

Example: 01 beep 18005551212 # # beep beep. This programs the Hotline Number to Dial with 1-800-555-1212

Page 1 To exit programming dial 99, wait for a beep, and hang up. If you have previously programmed the Mini HotDialer™ to dial when the handset is lifted you will have to wait for it to finish dialing before entering program mode! If you hear 4 beeps this means a program entry was incorrect.
Page 2 Connections for Dialing Triggered by an Optional Dry Closure: Register 01 – Hotline Number to Dial: When this register is programmed with a number the Mini HotDialer™ will dial this number automatically when the telephone handset is taken off hook.
Page 3 3. # # beep beep Register 13 – Call Restrict Mode: This register instructs the Mini HotDialer™ to restrict all outgoing calls, such as those entered with the dial on a phone or a hand-held pocket type DTMF dialer. When programmed to Restrict Outgoing Calls and a Hotdial Number is programmed in Register 01, any digits dialed after the Mini HotDialer™...
Page 4 When the telephone handset is lifted off-hook the Mini HotDialer™ waits this amount of time before acknowledging a valid off-hook and starting the dialing sequence. Example: You want the off-hook time to be 100 milliseconds before the Mini HotDialer™ thinks it’s OK to start dialing: 1. 17 beep 2.