Industrial Lighting Andromeda S Instructions For Use

Uv-c irradiator

Hide thumbs

INSTRUCTIONS FOR USE OF ANDROMEDA UV-C IRRADIATOR

Thank you for purchasing from us a bactericidal UV-C irradiator type

"Andromeda S" of "Industrial Lighting" Ltd.

Before using your UV-C irradiator, read the instructions carefully and

keep them for further reference.

1. Failure to follow the instructions below may result in electric shock, fire, and

/ or serious injury.

2. The appliance must be connected to the main electrical network directly

into the socket.

3. It is forbidden to use the appliance with a damaged cable or plug.

4. Keep the power cord away from busy areas. Never place the cable under

carpets, near radiators, stoves or other heating appliances.

5. Protect bactericidal lamps from impact.

6. Do not use the appliance near open water.

7. Do not touch the bactericidal lamps with dirty or wet hands. Only switch

the irradiator on and off with dry hands.

8. Unplug the power cord from the electrical outlet when the irradiator is not

in use, before cleaning, before inserting or removing parts, and before

moving the irradiator to another location.

9. Never drop or insert any objects into the openings of the irradiator.

10. Use the appliance only for its intended purpose as described in this

manual. It is forbidden to use the appliance for any other purpose.

11. The appliance is intended for indoor use only.

12. Do not use the power cord to pick up, carry, drag, pull, or lift the

irradiator. Do not pull the cord on or around sharp corners or edges. This can

damage the protective cover and damage the cable.

13. Do not pull on the power cord to unplug it.

14. Always switch off the irradiator before removing the plug from the socket.

15. Never place the irradiator on soft and unstable surfaces such as a bed or

sofa. This can cause the appliance to fall, tip over and be damaged.

16. Do not cover the irradiator during operation.

17. Clean the appliance only with a clean, dry cloth. Do not use detergents.

18. Store the irradiator on a smooth, level surface, away from direct sunlight.

Keep the power cord away from heated surfaces and places where a

person may walk or trip.

19. During normal operation, the bactericidal lamps glow evenly along their

entire length in a light blue color. If the color of the lamp's changes to purple-

red or the discharge starts to flicker, turn off the irradiator and replace the

lamps. If, even after replacing the lamps, they do not light up in normal

mode, turn off the irradiator and contact your dealer or authorized service

center. Bactericidal lamps have an average life of 9000 hours. During

ATTENTION!

READ AND SAVE THESE INSTRUCTIONS.

INDUSTRIAL LIGHTING LTD.

„

Kremikovsko shose" Str,№ 15, 1839 Sofia, Bulgaria

phone: +359 2 945 4212, fax: +359 2 945 4145,

WWW.INDUSTRIALLIGHTING.EU

office@industriallighting.eu

Table of Contents

Need help?

Do you have a question about the Andromeda S and is the answer not in the manual?

Questions and answers

Summary of Contents for Industrial Lighting Andromeda S

Page 1 +359 2 945 4212, fax: +359 2 945 4145, INSTRUCTIONS FOR USE OF ANDROMEDA UV-C IRRADIATOR Thank you for purchasing from us a bactericidal UV-C irradiator type "Andromeda S" of "Industrial Lighting" Ltd. Before using your UV-C irradiator, read the instructions carefully and keep them for further reference.
Page 2 INDUSTRIAL LIGHTING LTD. „ Kremikovsko shose“ Str,№ 15, 1839 Sofia, Bulgaria phone: +359 2 945 4212, fax: +359 2 945 4145, operation, the efficiency of the lamps in the UV-C area gradually decreases. It is possible for the lamps to glow even after 9000 hours in the visible region of the spectrum, but then their bactericidal efficiency is minimal and the radiation is not enough for normal disinfection.
Page 3 Bactericidal lamps from different manufacturers may have different durations of effective emission. The Andromeda S emitters are equipped with tubes made using OZONE FREE technology, ie. The special glass used in their production does not pass almost completely the ozone-forming mercury discharge line 185nm.
Page 4 • 30 minutes for a room from 75 m2 to 100 m2 • 60 minutes for a room from 100 m2 to 130 m2. Sequence of actions when working with "Andromeda S" irradiators 1. Make sure there are no people, pets or live plants in the room.
Page 5 Kremikovsko shose“ Str,№ 15, 1839 Sofia, Bulgaria phone: +359 2 945 4212, fax: +359 2 945 4145, Industrial Lighting Ltd. adheres to the recommendation of the National Center for Parasitic and Infectious Diseases. According to it, effective disinfection is achieved by operating the lamps for 20-30 minutes and a minimum of 6 µW / cm2 UVC intensity in the entire volume...