Page 1
Configuring the DMX CO2 Jet for your desired mode of control LOCAL Mode: To use the DMX CO2 Jet in Local mode, all that you need to do is flip the rocker switch to the LOCAL position (as shown in figure 1). Once the rocker switch is positioned in this mode, all other configuration switches become irrelevant.
Page 2
DMX Mode: To use the DMX CO2 Jet in DMX mode, you will need to do a little bit of configuring. For starters, you need to flip the rocker switch to the DMX position (as shown in figure 2). Figure 2 DMX Addressing: The next bit of configuration is to set the DMX512 address on the dipswitches (as shown in figure 3).
Page 3
With no DMX present, the LED flashes about once per second. When the DMX CO2 Jet is receiving valid DMX packets, the LED flashes at a much faster rate, many times per second. If a valid DMX stream is not sensed after a period of ~150ms, the LED will revert to a slow 1...