Advertisement
Quick Links
HUTCHENS DEVICE™
The products and parts shown herein are to be installed and used in accordance with these
instructions. Any deviation by the buyer, installer, or user from these instructions constitutes
willful negligence. Products and parts are not to be used if defective, damaged or worn.
Products and parts are not to be used after a severe use and, in any event, not after three (3)
years from the date of purchase.
Installation Manual
Hutchens Device V8 4/6/06
Advertisement
Summary of Contents for Safety Solutions HUTCHENS DEVICE
- Page 1 Products and parts are not to be used if defective, damaged or worn. Products and parts are not to be used after a severe use and, in any event, not after three (3) years from the date of purchase. Installation Manual Hutchens Device V8 4/6/06...
- Page 2 1-800-731-4404 Hutchens Device™ This device not recomended for use with an open face helmet. Single Hook Attachment Locate helmet hooks symmetrically on both sides of the helmet. The helmet hooks should be located per Figure 1 for a standard helmet and Figure 2 for a sidewinder style helmet.
- Page 3 1-800-731-4404 Hutchens Device™ Helmet Tether Helmet Tether A) Helmet Tethers Lace the helmet tethers provided, to the upper D-rings on the top of the Vertical straps on the Hutchens Device™. Per Diagram A. Helmet Tethers B) Leg Straps Quick Leg Strap...
- Page 4 Trim all tethers to optimal length for your size. Excess tether length can cause hang ups and obstruct the effectiveness of your Hutchens Device™. Cut the excess after fitting and burn the cut ends to prevent unraveling.” As with any restraint system, replace after severe use, or after 3 years of use.
- Page 5 1-800-731-4404 Hutchens Device™ 5. Pull the Quick Release bail to release. Attach the Quick release hook to the helmet D-rings on the helmet. The Quick releases should be routed into the D-ring from the “outside of the D-ring” to the inside, with the Quick Release tether pointed down on each side.
-
Page 6: Safety System
A Hutchens Device has been shown to be most effective in a system with properly mounted seat belts and a 6-point sub-belt system. The 6-point has been shown to better control the occupant’s pelvis earlier in the event. - Page 7 1-800-731-4404 Hutchens Device™ Attachment for a Camlock belt system Option 1: Option 1 Easiest - If using a 5-point or 6-point system with camlock. Insert left lap belt tongue through the tongue on the Hutchens Device™ then into buckle. (This configuration has been tested with no issues.)
- Page 8 1-800-731-4404 www.hutchensdevice.com As with any restraint system, replace after severe use, or after 3 years of use. WARNING: THIS ARTICLE IS SOLD WITHOUT WARRANTY, EXPRESSED OR IMPLIED. NO WARRANTY OR REPRESENTATION IS MADE AS TO THIS PRODUCTS ABILITY TO PROTECT THE USER FROM ANY INJURY OR DEATH. THE USER ASSUMES THAT RISK.