Peak Season 10010284 Assembly Instructions

Assembly Instructions
Thank you for purchasing this quality product. Be sure to check all packing materials carefully for small parts that may have come loose inside the carton during
shipment. Please read all instructions carefully before starting the assembly process. Perform all assembly steps on a flat, soft, non-abrasive surface. Do not
over-tighten the screws. CAUTION: Some items and/or the components are cumbersome and heavy. Therefore, the assistance of one or more people is
recommended in order to prevent personal injury and insure that the item and/or its components are not damaged during the assembly process.
For questions, missing parts or defectives, please contact Peak Season at 1-866-563-1732 or customerservice@peakseasoninc.net
Classic Aluminum Dining Table 50" Round
Step I. To properly assemble the Table Base first
align the table base 1 (B) with the table base 2 (C)
components provided, as shown in Figure 1.
Step II. Connect TOP PORTION of table base 1 (B)
with both table base 2 (C) components by adding
flat washer (G), spring washer (F) to the 80MM
screw (D) and maneuvering the 80mm screw
through the designated hole in table base 2 (C).
Then maneuver the screw so that it passes through
table base 1 (B) and through the table base 2 (C)
component on the opposite side. Add flat washer
(G) and nut (H) and fasten "by hand" to hold in
place.
Step III. Use the Allen wrench (J) provided to fasten
the screw, and use the hexagon wrench (K) to hold
the nut as you tighten to secure the base. Do NOT
over tighten the screws until the BOTTOM SECTION
has been secured. Once all screws have been
inserted, securely tighten each of the screws using
the Allen wrench (J) & hexagon wrench provided.
Step IV. Connect the BOTTOM PORTION of table
base 1 (B) with both table base 2 (C) components is
the same manner as noted in Step II. Apply the nut
caps (I).
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Model # 10010284
Page 1
Figure 1