Advertisement
Quick Links
Jammy Sol Series One
Instructions
Assembly and Lens Change
Your Jammy Sol Series One Lamp comes assembled with an installed Euro Beam Pattern. Changing the beam pattern is
simple. Just follow these instructions:
1) Remove the four screws holding the Face Plate in place.
2) Remove the Face Plate and Lens.
3a) For Spot Beam - Replace the Patterned Euro Lens with the clear un-patterned lens.
3b) For Flood Beam - Remove the Patterned Euro Lens AND Conical Chrome Reflector. Replace the Reflector with the
supplied Conical Plastic Flood Beam Optic and use the clear un-patterned lens.
4) Align the gasket securely into its channel and place the lens on top of the gasket.
5) Fasten the Face Plate over the lens and screw back into place. Tighten screws securely.
JAMMY, INCORPORATED
Post Office Box 471697, Fort Worth, TX 76147
817.737.6566 / Fax 737.5960 / 800.537.3136 / www.jammyinc.com
Advertisement
Summary of Contents for Jammy Sol Series One
- Page 1 Instructions Assembly and Lens Change Your Jammy Sol Series One Lamp comes assembled with an installed Euro Beam Pattern. Changing the beam pattern is simple. Just follow these instructions: 1) Remove the four screws holding the Face Plate in place.
- Page 2 Simple butt splices or quick connects will do. Linking Linking your Jammy Sol Series One lamps is easy. Simply slide the keyed Multi-Link Connector into one of the three Channels on the sides of the lamps and secure into place with a supplied screw. Then slide another lamp onto to the other end of the same Multi-Link Connector and fasten into place with the other supplied screw.