Fuel Supply; Start Up - PRETUL DES-25P Manual

• Follow the safety standards for handling fuel. (Page 5)
• Let the motor cool down completely before filling up.
• Set the string trimmer onto a flat surface leaning it as
shown in the figure.
• Wipe around the fuel tank cap to avoid contamination.
• Slowly loosen the fuel cap.
• Use care to avoid spillage. Pour the fuel mix into the fuel
tank. CAUTION Follow fuel specifications. (Page 3)
• Before setting back the fuel cap check and clean the
joints.
• Immediately cover the fuel tank cap and tighten by
hand.
• Wipe clean any fuel spill.
In a new motor and after using for the
CAUTION
first time is a normal that smoke emissions are present.
Starting with a cold motor
• Set the string trimmer in level ground where the cutter
head is not making contact with obstacles.
• Set the switch in the ON position (A).
• Press and release 10 times the starter choke (B).
• Move the choke lever into "
• Pull the starter 3 to 5 times (C) to let the fuel enter into
the motor. Then press the lock and the throttle trigger (D)
and pull the starter fast and with force to start the motor.
Do not release the starter. Put it back carefully into its
initial position to prevent damaging the starter.
• Once the motor starts set the choke lever into the "
position (2).
• Release the throttle trigger to make the motor run idle a
couple of minutes.
• The string trimmer is ready to be used. Hold it by its two
handles using both hands and lift it to start the job.
• Press the lock and throttle trigger to start the cutting device.
8
ENGLISH
" position (1).
"

Fuel supply

Start up

A
B
1
C
D
x6
2