Important Safety Instructions Please read these instructions carefully before operation. • Ensure that the power supply is 220 – 240 V / 50Hz. • Place the unit in a position with unrestricted airflow. • Do not cut off the power supply by pulling the power cable. •...
Button Instructions 1. ON / OFF : Switch the unit ON / OFF. The unit runs in this order: “ON – OFF – ON”. 2. Humidity Up / Down : Press once to increase / decrease humidity by 1% respectively. Press and hold for 1.5 seconds to increase the rate of adjustment.
Page 6
Notes 1. If the set humidity is higher than the current humidity, the unit will not run. To start the unit, please lower the humidity setting to at least 3% lower than the current humidity reading. 2. When the tank is full, the Full Tank indicator will light up. The compressor and fan motor will be shut off automatically, and the unit will alert the user by beeping twice.
When there are unusual burning smells or noises, the drainer well for smooth draining. switch off the power and unplug the unit. Seek technical advice from Dritech or your vendor. Fire, electric shock or component If the ambient temperature is near freezing damage may occur.
Page 8
Maintenance and Safety Do not disassemble or repair on your own Place the dehumidifier in a stable and flat position. unless you are trained and qualified. If unit tilts or turns over, there will be water Risk of electric shock, and damage spills or seepage, which may damage nearby to components.
Important Notes 1. When moving the unit, do not tilt it over 45° to avoid damaging the compressor. 2. The operating temperature is 5° - 32°C. Please ensure the room environment meets this requirement. 3. When the unit is running, the room temperature may rise slightly due to heat generated from the compressor and fan motor.
Additional Notes 1. If the issues cannot be rectified, please contact Dritech or your vendor for assistance. 2. Do not disassemble the unit unless your technicians are qualified. 3. When the unit starts or stops, some noise from the refrigerant pipeline is normal.
Need help?
Do you have a question about the HT-901 and is the answer not in the manual?
Questions and answers