Advertisement
Gas requirements
This appliance can be used with any brand of 20lb LP gas tank provided it is
z
compatible with a proper retention device (not supplied).
The LP gas cylinder must be:
z
Designed for use with a Type 1 system only.
z
Constructed and marked in accordance with the Specifications for LP gas Cylinders
z
of the U.S. Department of Transportation (D.O.T.) or the Standard for Cylinders,
Spheres and Tubes for Transportation of Dangerous Goods and Commission, CAN/
CSA-B339
Provided with a listed overfilling prevention device.
z
Provided with a cylinder connection device compatible with the connection for
z
outdoor cooking gas appliances
The cylinder must be provided with a shut-off valve terminating in an LP gas supply
z
cylinder valve outlet specified, as applicable, for connection Type 1.
Do not change the regulator/hose assembly from that supplied with the unit or attempt
z
to use a Type 1 equipped regulator/hose assembly with a standard 510 POL tank/valve
assembly.
Never use a cylinder with a damaged valve. The cylinder that is used must have a collar
z
to protect the cylinder valve.
An installer-supplied gas shut-off valve must be installed in an easily accessible location
z
All installer supplied parts must conform to local codes, or in the absence of local
z
codes, with the National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical
Code, CSA C22.1, and the National Fuel Gas Code, ANSI Z223.1 or CSA-B149.1 Natural
Gas Installation Code or CSA-B149.2 Propane Installation Code.
In Massachusetts such shut-off valves should be approved by the Board of State
z
Examiners or Plumbers & Gas Fitters.
All pipe sealants must be an ap proved type and resistant to the actions of LP gases.
z
Never use pipe sealant on flare fittings.
A dented or rusty LP tank may be hazardous and should be checked by your LP
z
supplier.
Always check for leaks after every LP tank change.
z
For LP units, check with a full cylinder.
z
Do not use the appliance until all connections have been checked and do not leak.
z
Before each use, inspect the gas supply piping or hose prior to turning the gas ON.
z
If there is evidence of cuts, wear, or abrasion, it must be replaced prior to use. The
replacement hose assembly shall be that specified by the manufacturer.
8
SAFETY AND WARNINGS
Advertisement
