Summary of Contents for tekton 6519
- Page 1 Model 6519 ® TUBING BENDER 5/16 O.D. OPERATOR’S MANUAL STORE THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE NEED HELP? Save time, contact us rst. 888-648-8665 support@tektontools.com...
- Page 2 BEND LAYOUT EXAMPLE FIG. 1 Vertex To measure tubing for bending, use the center line 5" of the tubing as shown. When establishing first measurement, make a REFERENCE mark for the starting point of measurement. In the example shown, a distance Reference of 5"...
- Page 3 COMMON BEND (Shown aligned for a 90˚ bend) FIG. 3 BEND Align the bend mark with the mark on the roll guide that corresponds to the bend angle. (Dashed lines indicate estimated positions.) 0 R L FIG. 3B 15˚ 30˚ 45˚...
- Page 4 REVERSE BEND (Shown aligned for a 90˚ reverse bend) FIG. 4 BEND Reference mark Sometimes it is necessary to bend tubing in a reverse position. For a 90˚ reverse bend, the BEND mark must align with the Bend "R" line on roll guide. Complete bending procedure described on page 3.
Need help?
Do you have a question about the 6519 and is the answer not in the manual?
Questions and answers