Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SmartDHOME MyPM01S
Summary of Contents for SmartDHOME MyPM01S
- Page 1 MyPM01S Meter for single-phase systems User manual Thank you for choosing the MyPM01S single phase meters powered by SmartDHOME. MyPM01S collects information in real time about the energy consumption of single-phase system. Ideal for prepaid energy supply services. www.smartdhome.com...
-
Page 2: General Safety Rules
Do not use the device in gas saturated environments. Do not place the device near heat sources. Use only the original accessories supplied by SmartDHOME. Do not place the connection and / or power cables under heavy objects, avoid paths near sharp or abrasive objects, prevent people from walking on them. -
Page 3: Intended Use
Power Supply and fixing MyPM01S doesn’t need batteries to be powered, it is powered directly from the line to which it is connected. It attaches easily, thanks to the 4-unit DIN bar. WARNING! To switch off the device, it is necessary to remove the power supply for about 20 seconds. -
Page 4: Data Sheet
MyPM01S Meter for single-phase systems User manual Real-time management At any time it is possible to remotely power on and off all the loads connected to the device; once this operation has been carried out, a confirmation message will be notified. - Page 5 MyPM01S Meter for single-phase systems User manual Dimension drawing (Unit: mm) Wiring and installing Wiring: auxiliary function 21-22: Modbus Interface 17-18: Pulse output 40-41: Reserved L1’ L1’...
- Page 6 MyPM01S Meter for single-phase systems User manual Installing To complete the installation of the device correctly, it is necessary to follow all the steps listed below. Note: It is advisable to have the installation of the device carried out by an authorized technician. If any anomalies occur...
- Page 7 MyPM01S Meter for single-phase systems User manual Pressing the button will be displayed: Total energy Unit price of electricity consumption Energy meter Electricity purchase time number Amount alarm 1 Max power, load control Amount alarm 2 Credit amount Max demand...
- Page 8 MyPM01S Meter for single-phase systems User manual If the energy meter NB/2G signal automatic switch or How many times it Quectel module number switch Energy meter type...
-
Page 9: Warranty And Customer Support
User manual Buttons There are four buttons on MyPM01S, used for device settings. The SET button is used to enter the setup screen and to return to the previous screen. This button is used to navigate between screens. Also, in case of changes to numeric settings, it is used to change the single numeric value.
Need help?
Do you have a question about the MyPM01S and is the answer not in the manual?
Questions and answers