Table of Contents
Summary of Contents for Sun Microsystems StorEdge DVD 10X
- Page 1 Sun StorEdge DVD 10X Installation and User’s Guide THE NETWORK IS THE COMPUTER ™ Sun Microsystems, Inc. 901 San Antonio Road Palo Alto, CA 94303-4900 USA 650 960-1300 Fax 650 969-9131 Part No.: 806-5518-10 Revision A, August 2000...
- Page 2 Sun, Sun Microsystems, the Sun logo, StorEdge, AnswerBook2, docs.sun.com, SunVTS, SunDiag, and Solaris are trademarks, registered trademarks, or service marks of Sun Microsystems, Inc. in the U.S. and other countries. All SPARC trademarks are used under license and are trademarks or registered trademarks of SPARC International, Inc. in the U.S. and other countries. Products bearing SPARC trademarks are based upon an architecture developed by Sun Microsystems, Inc.
- Page 3 Modifications to Equipment Do not make mechanical or electrical modifications to the Read this section before beginning any procedure. The equipment. Sun Microsystems is not responsible for following text provides safety precautions to follow when regulatory compliance of a modified Sun product.
- Page 4 System Unit Cover You must remove the cover of your Sun computer system unit in order to add cards, memory, or internal storage devices. Be sure to replace the top cover before powering up your computer system. Caution – Do not operate Sun products without the top cover in place.
- Page 5 SCSI-2 interface. The DVD-ROM drive uses standard 4.76-inch (120- millimeter) DVD or CD media. The StorEdge DVD 10X drive can run in five different modes: 1. CD-audio: 4-5.7X when audio is played 2. CD-RW: 8.6-20X for applications or data transfer 3.
-
Page 6: Installation Conditions
Note — When operating the unit vertically, and under the angle represented by the dotted lines in Figure 2, unbalanced media (greater than 1.0g-cm) may cause an audible hum to occur. This is considered normal operation. Sun StorEdge DVD 10X Installation and User’s Guide — August 2000... - Page 7 20˚ 20˚ 20˚ 20˚ Horizontal positioning 10˚ 10˚ 10˚ 10˚ 10˚ 10˚ 10˚ 10˚ Vertical positioning FIGURE 2 Drive Mounting Limitations Sun StorEdge DVD 10X Installation and User’s Guide — August 2000...
- Page 8 Set the jumpers to SCSI target ID 6 by installing jumpers ID4 and ID2 as in Figure 3. Power SCSI data SCSI connector connector FIGURE 3 StorEdge DVD 10X Drive — Rear View Sun StorEdge DVD 10X Installation and User’s Guide — August 2000...
-
Page 9: Handling And Storing Media
Cleaning If your StorEdge DVD 10X drive cannot read a media, the cause can be a dirty disc. Follow these guidelines to clean a disc: § Use a soft, clean, lint-free, dry cloth. § Clean the non-labeled side of the disc. -
Page 10: Drive Status
Note — If the drive remains inactive for approximately 32 minutes, the spindle motor stops, and the LED turns off. When the drive receives another command, the spindle motor starts and the LED automatically lights. Sun StorEdge DVD 10X Installation and User’s Guide — August 2000... -
Page 11: Performance Specifications
Performance Specifications The StorEdge DVD 10X operates at speeds of 4.1-10X for DVD and 17.2-40X for CD. Refer to Table 2 for more details. TABLE 2 Performance Specifications DVD (4.1-10X) CD (17.2-40X) Rotational, 5,800rpm 8,500rpm Data Transfer 5,540-13,500KBytes/s 2,595-6,000KBytes/s (mode 1) -
Page 12: Environmental Specifications
146 mm (5.75 inch) Depth 193 mm (7.48 inches) excluding bezel Weight 0.95 kg (net) (2.09 lbs) Power Requirements TABLE 5 Power Requirements Operational +5 VDC ±5% +12 VDC ±5% Sun StorEdge DVD 10X Installation and User’s Guide — August 2000...
Need help?
Do you have a question about the StorEdge DVD 10X and is the answer not in the manual?
Questions and answers