Activa TWIST CAR User Manual

TWIST CAR
USER MANUAL
PRODUCT INFORMATION AND TIPS:
The Twist Car is suitable for children ages 10 and up. The car is an electronic product so should be used under
adult supervision. To avoid injury or damage, do not modify or disassemble.
1. The remote control requires 2 1.5V AA non-rechargeable batteries.
2. The car requires one 6V 2/3AAA Ni-MH battery pack, which is a rechargeable battery pack..
3. Please note the polarity symbols to insert batteries correctly.
4. Do not attempt to recharge the non-rechargeable batteries.
5. Avoid short-circuiting the car.
6. Adult supervision is required when charging the rechargeable battery.
7. Check the cord, plug, power switch, enclosure and other parts regularly to ensure continued optimum
performance. Discontinue use if any parts are damaged.
8. When not in use, make sure that the power switch is "OFF" and remove the batteries in the car body and
remote control.
9. Do not immerse in water.
10. The packaging contains important information, keep it stored for future reference.
PRODUCT OVERVIEW:
Product confi guration
2.4G remote control X1 RC car X1
Part designations
2.4G remote control X1 RC car X1
Power switch
Power switch
6V
Rechargeable USB charging
battery pack X1 cable X1
6V
Rechargeable USB charging
battery pack X1 cable X1
Turn Left
Forward
Turn Right
Backward
Forward Turn Left
Turn Left
Forward
Transformation
Turn Right
Backward
Backward Turn Right
Transformation
Transformation
2X1.5v"AA"
2.4G remote control X1
REMOTE CONTROL INFORMATION AND INSTRUCTIONS:
2.4G remote control X1
1. P lace the batteries in the remote control. The indicator light of remote control will start fl ashing. Then, load
batteries in the car and switch it on. The car and remote signals will connect. Once connected, the fl ashing
indicator light will switch off.
Note: If the signal connection fails, repeat the steps above.
2. You can only use 1 remote control per car.
3. When the remote control fails to locate the car's 2.4G signal for one minute, it will automatically enter Sleep
Power switch
Mode. Press any button to exit the Sleep Mode.
BATTERY INSTALLATION:
Power switch
Remote Control-
1. Remove the remote control battery cover and load
batteries according to polarity symbols.
2. Replace the battery cover.
Twist Car-
1. Remove the battery cover underneath the car connect the
rechargeable battery pack to the power socket and place
in the battery box.
2. Replace the battery cover and secure with a screwdriver.
CHARGING THE BATTERY PACK:
1. Charge battery pack prior to fi rst use.
2. Connect the battery pack to the port of the USB charging
cable. Then plug in the USB charging cable to a socket.
3. Charging time is 3-4 hours. The USB cable indicator
light will turn red when charging and turn off when fully
charged. Do not over charge, it will not change battery
capacity limit.
4. Check the car battery, charging cable, plugs and other
parts regularly for optimum performance.
CAR CONTROL:
1. Turn on the car.
2. Push the direction lever of the remote control to let the car run
forward/backward or turn left/right.
3. Turn the power off when not in use.
4. Press the transformation button to transform the car. Note: Only 6V
one side transforms.
5. W hen fi nished using, turn off the car's power and the remote will
automatically enter sleep mode.
6V
OPERATING TIPS
:
1. Always ensure the power switch is 'ON' when the vehicle is being
operated.
2. A low battery will impact the car's movement capability.
3. The Twist Car's control range is approximately 40 meters (131
feet). The car will stop running once out of control range.
6V
Rechargeable USB charging
RC car X1 battery pack X1 cable X1
6V
Rechargeable USB charging
RC car X1 battery pack X1 cable X1
Turn Left
Forward
Turn Right
Backward
Forward Turn Left
Transformation
Turn Right
Backward
Transformation
2X1.5v"AA"
2X1.5v"AA"
6V
6V