Denon AVR-X2300W Service Manual page 110

1. Version Display Mode
1.1. Actions
Version information is displayed when the device is started in this mode.
1.2. Starting up
While holding down buttons "DIMMER" and "STATUS" simultaneously, press the power button to turn
on the power.
then press the "STATUS" button to display the information in section 1.3 on the display.
b The version list is also displayed on GUI while the version is displayed on the display.
1.3. Display Order
Error information (See "1.4. Error display") → q Model destination information → w Firmware Package
→ e Main µ-com → r Main 1st Boot Loader → t DSP ROM → y Audio PLD → u GUI SFLASH → i
Ethernet 1st Boot Loader, Hardware ID
→ o Ethernet 2nd Boot Loader, Rhapsody Flag → Q0 Ethernet IMAGE
→ Q1 Network MAC ADDRESS information → Q2 Bluetooth MAC Address information
q Model destination information :
AVR-S920W E3 *
AVR-X2300W \\\ *
\ ： Region (E3, E2, E1C, JP)
w Firmware Package :
Package :****
e Main µ-com :
Main :%%%%####*
% ： Main version, # ： Sub version
r Main 1st Boot Loader :
Main FBL :**.**
t DSP ROM :
DSP :**.**
y Audio PLD :
Audio PLD:**.**
u GUI SFLASH :
GUI :@@$\****
@ ： Model code, $ ： Brand code (DENON=1),
\ ： Region code (E3=1, E2=2, E1C=5, JP=4, ALL=0), * ： version
i Ethernet 1st Boot Loader, Hardware ID :
Ethernet FBL
Press "STATUS" button.
******-**
o Ethernet 2nd Boot Loader, Rhapsody Flag :
Ethernet SBL
Press "STATUS" button.
B************-0A
Q0 Ethernet IMAGE :
Ethernet IMG
Press "STATUS" button.
I************
Q1 Network MAC ADDRESS information：
*NET MAC Address
Press "STATUS" button.
******-******
Q2 Bluetooth MAC ADDRESS information：
*BT MAC Address
Press "STATUS" button.
******-******
110