Advertisement
HDL
®
Fixture1
Fixture2
(9) Insert an insertion between the fixtue1 and fixture2, and install the handle onto the
insertion, the handle should outward.
Insertion
Fixture1
Fixed-Caliper1
(10) Face to the reverse side of the rail, adjust the position of the track joiner, make its
middle part located in the gap of two rails, then outward stretch the rails with
hands (Purpose: to let the belt running smoothly), meanwhile tighten the screws
of the track joiner.
(11) At the reverse side of the rail, can screw in more than one ceiling brackets, they
are used for fixing the rail to the wall.
(12) Screw the motor into the drive unit, then clamp tightly and lock it( Notice: the host
motor should be installed to the side with the power supply; need to connect the
host and slave by the 6 core RJ11, the standard length of RJ11 wire is 1 meter.
Two plugs of the RJ11 have been pressed already, before use, need to connect
www.hdlautomation.com
Fixture2
Master Carrier1
Track Joiner
HDL-MWM70 Curtain Assembly Manual
Fixture1
Rubber
Fixturer2
Insertion
Track Joiner
接驳条
Master Carrier1
Handle
5
Advertisement
