Panasonic ET-PEN100 Operating Instructions

Names
Tip with touch sensor
Bofore using the pen
Install batteries.
Installing and Removing Batteries
1. Rotate as shown in the figure.
2. Install 2 AAA/R03 or AAA/LR03 type batteries.
* Remove the batteries in
the reverse order of installation.
Disposal of Old Equipment
Only for European Union and countries with recycling systems
This symbol on the products, packaging, and/or accompanying documents means that used
electrical and electronic products must not be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take them to applicable
collection points in accordance with your national legislation.
By disposing of them correctly, you will help to save valuable resources and prevent any
potential negative effects on human health and the environment.
For more information about collection and recycling, please contact your local authority.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national
legislation.
Panasonic Connect Co., Ltd.
Web Site : https://panasonic.net/cns/projector/
© Panasonic Connect Co., Ltd. 2022
Thank you for purchasing this Panasonic product.
• Before using this product, please read this
instructions and "LightPenII: Operation Manual"
completely, and save this manual for future use.
How to use the pen
While pressing the tip against a hard screen,
the tip of the pen and the LED for the internal
infrared ray will both light. This is sensed by the
infrared ray sensor on the front of the projector,
Power button
and the location of the tip of the pen is detected.
1) Press the power button to turn the power on.
2) Place the tip of the pen anywhere on the
3) By pressing the tip against a hard screen,
Attention
Since there is a touch sensor inside the tip of the pen,
pushing or bending the tip will consume battery power.
In order to prevent unnecessary battery consumption
when not in use, press the power button to turn the
power off. (Press the tip of the pen to confirm that the
LED does not light.)
Product Information (for Turkey only)
AEEE Yönetmeliğine Uygundur.
Operating Instructions
Interactive Pen
Model No.
screen.
you can drag. In pen mode, you can draw
lines.
Commercial Use
ET-PEN100
ENGLISH
Printed in Taiwan
1LG6P1P1022-- (IJDV)
TQZJ711-2