MTX 350079 User Manual page 2

LASER LEVEL, PLUMB LINE
2
Used for tiling, installation of windows, doors, hanging of paintings and etc., also for laying of pipes and
wiring.
DELIVERY COMPLETENESS
1. Square laser maker— 1 pcs.
2. Manual — 1 pcs.
№ Specification
1 Dimensions, mm
2 Laser wave length, Nm
3 Output power, mW
4 Deviation, mm/m
5 Battery AAA
6 Battery life, h
7 Operating temperature, °С
8 Storage temperature, °С
9 Weight, gr
4
3
5
2
1. Switch. 5. Housing.
2. Button. 6. Angle scale.
3. Bubble level. 7. Suction cup.
4. Laser. 8. Battery compartment.
CORRECT USE
TECHNICAL DATA
Value
191 × 100 × 50
650
<1
±1
1,5 V × 3 pcs.
Up to 8 hours in continuous mode (alkaline battery).
0–40
-10–45
154
ASSEMBLY
7
1
3
6
1. Do not operate this device under direct sunlight, high temperature and humidity.
2. Do not drop the device and avoid strong shocks.
3. Do not dismantle the laser.
4. The responsibility for any improper use is carried by user.
5. If the device is placed in storage, be sure to disconnect the power and remove the battery.
1. Open the battery compartment cover and insert three AA batteries (drawing 1).
2. Align the laser using the 2 bubble chamber. The bubbles must be placed in the middle, between two
graduation marks
3. Fix the laser housing by two suction cups , pre-damp it and pressing 2 buttons.
4. Press the switch. Laser begins to show 2 beams under angle (drawing 2).
Do not look into the laser beam and don't point the laser beam directly into the eyes of others,
cars or aircraft. This can lead to serious damage to the eye.
Do not point the laser beam at mirrors or other similar surface.
8
LASER LEVEL, PLUMB LINE
OPERATING RULES
ORDER OF WORK
Drawing 1
SAFETY RULES
3
90°
Drawing 2