Page 1
User and Installation Instructions Seal Heated Display Bars HB2, HB3, HB4, LD2, LD3, LD4 IS280 ECN2841...
Page 2
Used for the purposes for which it is intended, and with careful maintenance as outlined in this User Guide, your Lincat product will give years of trouble free use. IMPORTANT INFORMATION Please read all of the safety and operating instructions carefully before using this product.
CONTENTS Contents Page Safety instructions………………………………………………………4 Product specification………………………………………………….. 5 Features………………………………………………………………….. 5 Technical specification…………………………………………………5 Pack contents…………………………………………………….………5 Spare parts list………………………………………………………….. 5 Installation……………………………………………………………….. 6 Connecting to the electricity supply……………………………. 6 Operating instructions………………………………………………….7 Cleaning and maintenance……………………………………………. 7 Service information…………………………………………………….. 8 Conditions of guarantee…..…………………………………….…….. 8 USE OF THE HEATED DISPLAY UNITS The Heated Display Units are intended to be used on counter tops to display pre-heated food products.
Do not try to modify this product. Ensure that the electrical supply cable is not damaged. If the supply cable is damaged, it should be replaced by Lincat Ltd or suitably qualified persons, in order to avoid a hazard. EQUIPOTENTIALITY This equipment is provided with an equipotential bonding terminal to allow earth cross-bonding with other equipment.
INSTALLATION Ensure the unit is installed on a sound, level work surface, which is heat resistant e.g. stainless steel or Formica ®. The unit’s external surfaces and base will become hot. You should inform your personnel and customers accordingly. Do not remove the feet otherwise the unit will overheat. NOTE For safety regulations, the plug must always be accessible.
OPERATING INSTRUCTIONS Connect the unit to the electricity supply. Ensure that the cable (4) is in good condition. Switch the unit on (2) and turn the temperature controller (1) to the desired setting. Wait for about 20 minutes for the unit to heat up.
Product code, type number and serial number of unit (both on serial plate) Code number of spare part (see spare parts list P. 5), if known Lincat reserve the right to carry out any work under warranty during normal working hours, i.e. Monday to Friday, 8.30 a.m. – 5.00 p.m.