Subscribe to Our Youtube Channel
Related Manuals for AutoAqua Titanium S2
Summary of Contents for AutoAqua Titanium S2
- Page 1 Change for Simple Change for Simple Digital Inline TDS TDS-100 TDS-100S TDS-200S TDS-300S...
- Page 2 Change for Simple Installation 1. Remove the battery insulation tab. 2. Insert the sensor fully into the union tee and make sure the sensor pins are perpendicular to the direction of the union tee as shown in the diagram. Both pins should be seen when looking through the union tee so the water will flow over both pins equally.
- Page 3 Change for Simple Calibration 1. Purchase a certified calibration solution that meets your requirements. 2. Disconnect the sensor from the union tee and dry. 3. Place the sensor in the calibration solution and keep the sensor pins submerged. 4. Press the power button to turn on the TDS monitor. Check if each sensor reading is correct by pressing the power button again to switch between TDS sensors (S2 and S3 only).
- Page 4 Battery Life : 1 year Size : 2 x 0.6 inch / 51 x 14.5 mm (Diameter x Thickness) Limited Warranty 1. Limited warranty is provided by AUTOAQUA only if your AUTOAQUA Product ("Product") was purchased from an authorized distributor or an authorized reseller.
Need help?
Do you have a question about the Titanium S2 and is the answer not in the manual?
Questions and answers