Table of Contents
Advertisement
Quick Links
UCONNECT 8.4" Installation Instructions:
Art. 300 313
1. Remove Screen from vehicle and find clean place
to open screen to insert PCB.
3. Carefully separate the back from the screen.
Take care not to break the wire in between.
5. Remove the metal bracket behind the screen as
shown above.
2. Remove 5 screws from behind the screen as
shown above.
4. Carefully remove the wire connected to the main
PCB board to separate the back completely.
6. Remove the 68Pin cable from the main screen as
shown above carefully.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CarVision UCONNECT
Summary of Contents for CarVision UCONNECT
- Page 1 UCONNECT 8.4" Installation Instructions: Art. 300 313 1. Remove Screen from vehicle and find clean place 2. Remove 5 screws from behind the screen as to open screen to insert PCB. shown above. 3. Carefully separate the back from the screen.
- Page 2 7. Plug our small 68Pin cable back into the original 8. Insert the 68Pin cable of the original car plate cable outlet. into the cable port provided PCB. 9. Insert the video cable into our small board and 10. Cover the housing. When installing, pay fix it on the small board (the video cable needs to attention to the position of the internal small board pull a gap as shown above).
Need help?
Do you have a question about the UCONNECT and is the answer not in the manual?
Questions and answers