Lakeland Mills ALT38 Quick Start Manual

Please check contents before assembly. If any items are missing or damaged, do not take the unit back to the store.
Call 1-800-427-5136 for customer service and we will save you time by correcting any problems directly for you.
BED COMPONENTS
1 Each - Assembled Head/Foot
3 - Mattress Supports
Twin support rails 38 1/2"
Double support rails 54"
Cracks or Checks in logs are part of the
NOTE:
natural beauty of cedar logs and should not be
considered defects.
NOTE: Read all instructions before starting.
CALIFORNIA PROPOSITION 65 WARNING
This product may have an indoor finish applied that contains For-
maldehyde (50-00-0), a substance known to the State of California
to cause cancer.
For more information go to www.P65Warnings.ca.gov
STEP 1 Assemble headboard by laying long headboard legs and one
assembled Head/Foot board on a clean flat surface, with lower
headboard leg hole facing up (recessed hole should be facing
the floor) and the top holes facing inward. Use a rubber mal-
let or hammer and block of wood to align and insert doweled
ends of the assembled headboard into the leg. Repeat process
on other leg. Repeat same process for the assembled foot-
board. See figure 1.
NOTE: Cracks or checks in logs are a
natural phenomenon that occurs when
moisture escapes as the logs dry and sea-
son. They do not affect the structural integ-
rity of the wood and are not considered
defects.
ALT38 Twin Log Bed
ALD53 Double Log Bed
2 - Bed Rails
2 Each - Head
& Footboard
Legs
Legs are drilled as
lefts and rights.
4 - Angle Braces
HARDWARE & TOOLS REQUIRED
22 - 2 1/2" Screws
4 - 1/4" x 5" Hex Washer Head Screws
Rubber Hammer
Mallet & Block
of Wood
or
HELPFUL TIPS:
 Using a battery operated or electric drill will make assem-
bly faster and easier.
 If finishing yourself, tape off all doweled ends. (Finishes
may cause dowels to swell, making assembly difficult.).
4 - 5/16"
washer
#2 Phillips
Screwdriver
7/16" Socket
or Wrench
or
or
Figure 1