™
Q-Beam
Brightsmith Max
14 LED Aluminum Flashlight w/ Lanyard
™
READ MANUAL FULLY BEFORE USING
BEFORE FIRST USE: Open and remove battery
sticker to allow batteries to operate.
BATTERY REPLACEMENT: Install batteries
by first unscrewing tail cap. Remove battery
compartment. Insert 3 AAA batteries into
battery compartment; two with positive (+) ends
toward head of lfashlight, one with negative
(-) end toward head of
flashligt (Fig. 1). Re-insert
battery compartment into
flashlight with positive (+)
end toward flashlight head.
Make sure spring is in
place in tail cap. Replace
tail cap by screwing in securely. Use alkaline
batteries for maxiumu brightness and life.
NOTE: Do not mix old and new batteries.
Figure 1
Do not mix
alkaline, standard
(carbon - zinc),
or rechargeable
(nickely cadmium)
batteries.
PUSH BUTTON SWITCH: Simply push button
switch to activate lighting modes: High, Low,
Strobe, Off.
BULB REPLACEMENT: LEDs (Light Emitting
Diodes) never need replacement.